SLVUCG4 October   2022 TPSM82912 , TPSM82913

 

  1.   TPSM8291xEVM Evaluation Module
  2.   Trademarks
  3. 1Introduction
    1. 1.1 Performance Specification
    2. 1.2 Modifications
      1. 1.2.1 Input and Output Capacitors
      2. 1.2.2 Configurable Enable Threshold Voltage
      3. 1.2.3 NR/SS Capacitor
      4. 1.2.4 Feedforward Capacitor
      5. 1.2.5 S-CONF Resistor
      6. 1.2.6 Single LC Filter Operation
  4. 2Setup
    1. 2.1 Input and Output Connector Descriptions
    2. 2.2 Ripple Measurement Setup
  5. 3 Test Results
  6. 4 Board Layout
  7. 5Schematic and Bill of Materials
    1. 5.1 Schematic
  8. 6Bill of Materials

Board Layout

This section provides the EVM board layout and illustrations in Figure 4-1 through Figure 4-5. The Gerbers are available on the EVM product page.

GUID-20220902-SS0I-NRZH-DBTL-9C8X0VLJ1J8N-low.gif Figure 4-1 Top Assembly
GUID-20220902-SS0I-L99C-LHKS-RBZT53THDJFP-low.gif Figure 4-2 Top Layer.

GUID-20220902-SS0I-XJ5F-TWSG-GWX4M40ZBSVV-low.gif Figure 4-3 Internal Layer 1 .
GUID-20220902-SS0I-GDZT-1QBZ-7MMJNHSGMDLT-low.gif Figure 4-4 Internal Layer 2.

GUID-20220902-SS0I-ZB5M-0QZD-F3L298HZXDHD-low.gif Figure 4-5 Bottom Layer