SNAU163C August   2014  – October  2016 FDC1004

 

  1.   FDC1004EVM User's Guide
    1.     Trademarks
    2. 1 Setup
      1. 1.1 FDC1004EVM
      2. 1.2 Input/Output Connector Description
      3. 1.3 HW Setup
    3. 2 Sensing Solutions EVM GUI
      1. 2.1 System Requirements
      2. 2.2 Installation Instructions
      3. 2.3 Starting the GUI
      4. 2.4 Navigating the GUI
      5. 2.5 Connecting the EVM
      6. 2.6 Configuring the EVM Using the Register Page
        1. 2.6.1 Automatically Update GUI Register Values Using Auto-Read
        2. 2.6.2 Manually Update Device Register Values
        3. 2.6.3 Reading Register Values without Auto-Read
        4. 2.6.4 Saving Device Configurations
        5. 2.6.5 Loading Previously Saved Configurations
      7. 2.7 Configuring the EVM Using the Configuration Page
      8. 2.8 Streaming Measurement Data
        1. 2.8.1 Choosing the Graph and Visible Channels
        2. 2.8.2 Logging Data to a File
        3. 2.8.3 Starting and Stopping Data Streaming
        4. 2.8.4 Data Statistics
        5. 2.8.5 Configuring the Graph
        6. 2.8.6 Navigating the Data Streaming Buffer
      9. 2.9 Updating the EVM Firmware
    4. 3 Board Layout
    5. 4 Schematic
  2.   Revision History

2.5 Connecting the EVM

Follow these steps to connect the EVM to the GUI:

  1. Attach the EVM to the computer via USB
  2. The GUI always shows the connection status on the bottom left corner of the GUI
    3. 3_gui_connecting_fdc1004_connected.pngFigure 16. FDC1004 Connected to GUI