SNAU277C April   2022  – October 2024 LMK6C , LMK6D , LMK6H , LMK6P

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Evaluation Module Contents
    3. 1.3 Evaluation Setup Requirement
  6. 2Hardware
    1. 2.1 Setup
      1. 2.1.1 Connection Diagram
      2. 2.1.2 Power Supply
      3. 2.1.3 Clock Output
      4. 2.1.4 EVM Strap Options
        1. 2.1.4.1 J1 Header
        2. 2.1.4.2 J2 Header
        3. 2.1.4.3 J3 Header
        4. 2.1.4.4 J4 Header
        5. 2.1.4.5 J6 Header
        6. 2.1.4.6 J7 Header
        7. 2.1.4.7 J8 Header
      5. 2.1.5 Configuring the Clock Output Termination
  7. 3Implementation Results
    1. 3.1 Typical Measurement
      1. 3.1.1 Phase Noise
  8. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layout and Layer Stack-Up
      1. 4.2.1 PCB Layer Stack-Up
      2. 4.2.2 PCB Layout
    3. 4.3 Bill of Materials
  9. 5Additional Information
    1. 5.1 Trademarks
  10. 6References
  11. 7Revision History

2.1.3 Clock Output

To test the clock output of Y1, connect P1 (+) and P2 (–) SMA connectors to an oscilloscope or phase noise analyzer. To test the clock output of Y2, use P3 (–) and P4 (+). The output frequency, amplitude, and common-mode voltage depends on the LMK6x variant that is attached to the board, as well as the termination scheme.