SNAU282 September   2022

 

  1.   Abstract
  2.   Trademarks
  3. 1Evaluation Board Kit Contents
  4. 2Quick Start
    1. 2.1 Quick Start Description
      1. 2.1.1 Clock Outputs Page Description
      2. 2.1.2 TICS Pro Tips
  5. 3PLL Loop Filters and Loop Parameters
    1. 3.1 PLL1 Loop Filter
    2. 3.2 PLL2 Loop Filter
  6. 4Default TICS Pro Mode
  7. 5Using TICS Pro to Program the LMK04832-SEP
    1. 5.1 Start TICS Pro Application
    2. 5.2 Select Device
    3. 5.3 Program the Device
    4. 5.4 Restoring a Default Mode
    5. 5.5 Visual Confirmation of Frequency Lock
    6. 5.6 Enable Clock Outputs
  8. 6Evaluation Board Inputs and Outputs
  9. 7Recommended Test Equipment
  10. 8Schematics
  11. 9Bill of Materials
  12.   A USB2ANY Firmware Upgrade
  13.   B TICS Pro Usage
    1. 11.1  Communication Setup
    2. 11.2  User Controls
    3. 11.3  Raw Registers Page
    4. 11.4  Set Modes Page
    5. 11.5  Holdover Page
    6. 11.6  CLKinX Control Page
    7. 11.7  PLL1 and 2 Page
    8. 11.8  SYNC / SYSREF Page
    9. 11.9  Clock Outputs Page
    10. 11.10 Other Page
    11. 11.11 Burst Mode Page

4 Default TICS Pro Mode

TICS Pro saves the state of the selected LMK04832-SEP device when exiting the software. Table 4-1 lists the available modes for the software. To ensure a common starting point, go to the Default Configuration menu and select the appropriate device configuration for your device.

Table 4-1 Default TICS Pro Modes for the LMK04832-SEP
DEFAULT TICS PRO MODEDEVICE MODECLKin FREQUENCYOSCin FREQUENCY
CLKin1 122.88 MHz, OSCin 122.88 MHz, VCO1 2949.12 MHzDual PLL, Internal VCO122.88 MHz122.88 MHz
GUID-20220914-SS0I-MGJ9-QZ5G-3F2QP5R7DT43-low.pngFigure 4-1 Selecting a Default Mode for the LMK04832-SEP Device.