SNLU210C July   2016  – April 2024 DS90UB933-Q1

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
  6. 2Hardware
    1. 2.1 Requirements
    2. 2.2 Major Components of DS90UB933-Q1EVM
    3. 2.3 Board Setup Details
      1. 2.3.1 Power Connections
      2. 2.3.2 FPD-Link III Connection
      3. 2.3.3 LVCMOS Input Connector Description (on DS90UB933-Q1 Board)
      4. 2.3.4 Factory Set Switch Settings and Jumpers Default Configuration
        1. 2.3.4.1 Serializer Board Default Configuration
    4. 2.4 Operation with Deserializer
    5. 2.5 Troubleshooting the EVM Setup
  7. 3Software
    1. 3.1 Using I2C
      1. 3.1.1 Default Addresses
      2. 3.1.2 Analog Launch Pad (ALP)
  8. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layout
      1. 4.2.1 DS90UB933-Q1EVM Serializer Board Layout
    3. 4.3 DS90UB933-Q1EVM Serializer Board Bill of Materials
  9. 5Additional Information
    1. 5.1 Trademarks
  10. 6Revision History

6 Revision History

Changes from Revision B (December 2017) to Revision C (April 2024)

  • Updated EVM user's guide format to the latest standardsGo
  • Added a new diagram of the DS90UB933-Q1EVM (Revision C)Go
  • Updated schematic to be text searchable and include the latest schematic changes made to Revision C of the EVM. Go
  • Updated the PCB layer images to include the latest layout changes made to Revision C of the EVMGo
  • Updated the BOM table to match the component changes made to Revision C of the EVMGo

Changes from Revision A (October 2016) to Revision B (December 2017)

  • Changed power supply voltage and current requirement to be compatible with DS90UB934Go
  • Changed compatible deserializer board to DS90UB934Go
  • Changed schematic images to include DNP components, R18, C15,C16,C21,C29. Go
  • Changed Top layer silkscreen to show CE markGo
  • Changed BOM to include DNP components, R18,C15,C16,C21,C29Go
  • Changed layout to new formatGo

Changes from Revision * (July 2016) to Revision A (October 2016)

  • Changed schematic images to include DNP components. Also revised dummy termination network on DOUT- to be terminated with 49.9Ω resistor instead of 57.6Ω.Go
  • Changed BOM to include DNP components and also changed 57.6Ω termination resistor on negative (-) DOUT terminal to 49.9ΩGo