SNLU296A December   2022  – December 2022 DS560MB410

 

  1.   DS560MB410EVM User's Guide
  2.   Trademarks
  3. 1Features
  4. 2Applications
  5. 3Ordering Information
  6. 4Setup
    1. 4.1 Modes of Programmable Communication
    2. 4.2 Configuration Overview
  7. 5SigCon Architect
    1. 5.1 Installation
    2. 5.2 Configuration
      1. 5.2.1 Establishing a Connection
      2. 5.2.2 Enabling Demo Mode
    3. 5.3 High Level Page
      1. 5.3.1 Device Status
      2. 5.3.2 Block Diagram
      3. 5.3.3 Crosspoint Switch
    4. 5.4 Low Level Page
    5. 5.5 EEPROM Page
    6. 5.6 Eye Height Page
  8. 6Common Problems and Suggested Solutions
  9. 7Bill of Materials
  10. 8EVM Cable Assemblies
  11. 9Revision History

5.1 Installation

Prerequisites:

  • SigCon Architect 3.0
  1. Use your web browser to download the DS560MB410 SigCon Architect profile installer from the product page on TI.com.
  2. Once the installer has downloaded, extract the installer from the .zip file and run the executable file.
  3. When the executable runs, a setup wizard will appear as shown in Figure 5-1. It is recommended to close any running programs prior to proceeding.
    GUID-20211116-SS0I-6QM0-6ZKX-HNCTSD3PGK3T-low.png Figure 5-1 DS560MB410 Profile Installer
  4. Read through the licensing agreement, and accept the terms of the agreement by selecting I Agree.
    GUID-20211116-SS0I-PNP1-9NQG-NN0CGXHR8SGZ-low.png Figure 5-2 DS560MB410 Profile License Agreement
  5. When complete, the user will be presented with an Installation completed window, shown in Figure 5-3. Press Finish to continue. If Run SigCon Architect EVM GUI v3 is selected, then SigCon Architect 3.0 will open.
    GUID-20211116-SS0I-V336-XZBN-0SZ3BP7J8HVK-low.png Figure 5-3 DS560MB410 Profile Installation Complete