SNVA757D August 2017 – September 2020 LP8860-Q1
The LP8860H-Q1 is configured for four strings × 80 mA using a 5-V VDD and PWM pin to control brightness. Table 2-15 lists detailed configurations and full EEPROM information for LP8860H-Q1.
H | ||
---|---|---|
Boost | Switching Current Limit | 4 A |
SYNC Input | Disabled | |
2 × Charge Pump | Disabled | |
Spread Spectrum | Disabled | |
ƒSW | 800 kHz | |
VDD | 5 V | |
Initial Boost Voltage | 25 V | |
LED Driver | Input Brightness Control Method | PWM pin input (direct) |
Maximum LED current per channel | 80 mA | |
ISET Resistor Control | Disabled | |
Number of Channels | 4 strings | |
Channel Phase Shift | 90 degrees (4 phases) | |
LED Output Dimming Method | PWM | |
Current to PWM Switch Point | N/A | |
Current Linearity Correction Slope | N/A | |
Output PWM Dimming Frequency | 4.883 kHz | |
Dimming Resolution | 10-bit PWM + 4-bit dither | |
Drive Strength and Rise Time | 200 ns | |
Dimming Ratio | 1024:1 | |
Sloper | 105 ms + advanced slope | |
Driver Headroom Voltage | VSAT + 50 mV | |
Fault Handling | Short LED Fault Threshold | 6.9 V |
VIN OVP Level | 22.5 | |
VIN UVLO Level | 5 V | |
VDD UVLO | 3 V | |
Input OCP Limit | 6 A | |
Powerline FET Type | PMOS | |
SD Pulldown Current | 440 µA | |
Temperature Compensation | Internal Temperature Compensation | Disabled |
External Temperature Compensation | Disabled | |
Current Dimming Knee Point | N/A | |
EXT_TEMP_GAIN[3:0] | N/A | |
EXT_TEMP_LEVEL_HIGH[3:0] | N/A | |
EXT_TEMP_LEVEL_LOW[3:0] | N/A | |
VSYNC and PLL | PLL | Disabled 5-MHz oscillator |
VSYNC input | Disabled | |
SYNC or HSYNC | N/A | |
PWM_SYNC | N/A | |
Pre-divider | N/A | |
Slow PLL Divider | N/A | |
R_SEL | N/A | |
SEL_Divider | N/A | |
PWM_FREQ | N/A | |
PWM_RES | N/A |
ADDRESS (HEX) | VALUE (BIN) | VALUE (HEX) |
---|---|---|
60 | 11101100 | EC |
61 | 11001100 | CC |
62 | 01011100 | 5C |
63 | 11010000 | D0 |
64 | 11010111 | D7 |
65 | 11100101 | E5 |
66 | 01110000 | 70 |
67 | 01110111 | 77 |
68 | 01110111 | 77 |
69 | 01110001 | 71 |
6A | 00111011 | 3B |
6B | 10110111 | B7 |
6C | 00010111 | 17 |
6D | 11101111 | EF |
6E | 00010000 | 10 |
6F | 10001011 | 8B |
70 | 11000100 | C4 |
71 | 00110101 | 35 |
72 | 11100101 | E5 |
73 | 00010010 | 12 |
74 | 01000101 | 45 |
75 | 11000110 | C6 |
76 | 10001100 | 8C |
77 | 11111111 | FF |
78 | 00111110 | 3E |
Figure 2-8 shows the use case for the LP8860H-Q1.