SNVU658B March   2020  – May 2021 TPS54J060 , TPS54J061

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Background
    2. 1.2 Performance Specification Summary
    3. 1.3 Modifications
      1. 1.3.1 Output Voltage Setpoint
      2. 1.3.2 Frequency and Operation Mode Setting
      3. 1.3.3 Enable Pin Selection
      4. 1.3.4 Adjustable UVLO
  3. 2Test Setup and Results
    1. 2.1  Input/Output Connections
    2. 2.2  Start Up Procedure
    3. 2.3  Efficiency
    4. 2.4  Load and Line Regulation
    5. 2.5  Load Transients
    6. 2.6  Loop Characteristics
    7. 2.7  Output Voltage Ripple
    8. 2.8  Input Voltage Ripple
    9. 2.9  Powering Up and Down with EN
    10. 2.10 Powering Up and Down With VIN
    11. 2.11 Start-Up Into Pre-Bias
    12. 2.12 Current Limit
  4. 3Schematic, List of Materials, and Layout
    1. 3.1 Schematic
    2. 3.2 List of Materials
    3. 3.3 Layout
  5.   Revision History

Revision History

Changes from Revision A (September 2020) to Revision B (May 2021)

  • Updated user's guide titleGo

Changes from Revision * (March 2020) to Revision A (September 2020)

  • Added TPS54J061 throughout the documentGo
  • Added TPS54J061EVM-067 throughout the documentGo
  • Added TPS54J061 to Table 1-1.Go
  • Added TPS54J061 and added line in Table 1-2 for TPS54J061 soft-start time.Go
  • Changed text to include TPS54J061 considerations.Go
  • Changed TPS54J060 to device.Go
  • Changed Figure 2-1 through Figure 2-8 to match latest measurements.Go
  • Changed the title of Figure 2-17 from No Load to 0.1-A loadGo
  • Changed the title of Figure 2-20 from No Load to 0.1-A loadGo
  • Added paragraph describing TPS54J061 hiccup current limit, Figure 2-28 and Figure 2-29.Go
  • Changed TPS54J060EVM-067 to BSR067.Go
  • Updated Figure 3-1 to latest version with R13 and Added Figure 3-2 for the TPS54J061EVM-067Go
  • Updated Table 3-1 to latest version with R13 and added Table 3-2 for the TPS54J061EVM-067Go
  • Changed TPS54J060EVM-067 to BSR067. Changed Figure 3-3 to Figure 3-10 for added R13 in BSR067B layout.Go