SNVU825 May   2022 DP83TC813R-Q1 , DP83TC813S-Q1

 

  1. 1Revision History
    1.     Trademarks
  2. 2Introduction
    1. 2.1 Key Features
    2. 2.2 Operation – Quick Setup
      1. 2.2.1 Onboard Power Supply Operation
      2. 2.2.2 SMI Connection and Communication
        1. 2.2.2.1 Onboard MSP Connection
        2. 2.2.2.2 Downloading USB2MDIO for SMI
        3. 2.2.2.3 SMI Interface
      3. 2.2.3 Master and Slave Mode Selection – DP83TC813
      4. 2.2.4 Autonomous/Managed Selection – DP83TC813
      5. 2.2.5 LED Indication
  3. 3Board Setup Details
    1. 3.1 Block Diagram
    2. 3.2 Configuration Options
      1. 3.2.1 Clock Configuration
  4. 4Definitions
  5. 5Schematics
    1. 5.1 Main Block Schematic
    2. 5.2 DP83867 Schematic
    3. 5.3 Power Schematic
    4. 5.4 AFE Schematic
    5. 5.5 Comms Schematic
    6. 5.6 Hardware Schematic
  6. 6Layout

2.2.5 LED Indication

  • Look for LED to illuminate on the RJ45 when a link is successfully established on the DP83867
  • LED_1 (D2) will turn only if R17 is populated (DNP by default). This pin is CLKOUT by default and would need to be programmed accordingly.