SPRADI0 July   2024

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
    1. 1.1 Getting Started
  5. 2Model-Based Design of eCompressor
    1. 2.1 General Texas Instruments High Voltage Evaluation (TI HV EVM) User Safety Guidelines
    2. 2.2 Block Diagram
    3. 2.3 Hardware, Software and Testing Requirements
      1. 2.3.1 Hardware setup
      2. 2.3.2 Software setup
      3. 2.3.3 Test Procedure
  6. 3 Simulink Configuration Settings
    1. 3.1 Simulink Tool Optimization
      1. 3.1.1 Optimum Code Generation
    2. 3.2 C2000 Specific Optimization
      1. 3.2.1 Using TMU Through Simulink
      2. 3.2.2 Using Software Libraries Through Simulink
      3. 3.2.3 Running Code From RAM
    3. 3.3 Performance Comparison
  7. 4 Profiling Using Simulink
    1. 4.1 Processor-in-loop (PIL) Method
    2. 4.2 C2000 Timer-Based Profiling
    3. 4.3 Code Composer Studio tools
  8. 5Summary

3 TIDM-02012 Simulink Configuration Settings

One of the key challenges while using model-based design is to generate optimized code for the C2000 MCU. While generating the code using C2000 Microcontroller Blockset, there are two stages of optimizations in use – Simulink tool optimization and C2000 specific optimizations. To generate the most optimal code for the application, each of the mentioned optimization needs to be configured. It is to be noted that, while we discussed about the TIDM-02012 eCompressor application in the previous section, the optimization settings that are discussed here are generic and can be applied for efficient code generation for all applications.