SPRUJ12F August   2021  – January 2024 AM2431 , AM2432 , AM2434

1.   1
2.   Abstract
3.   Trademarks
4. 1Preface: Read This First
   1. 1.1 If You Need Assistance
   2. 1.2 Important Usage Notes
5. 2Kit Overview
   1. 2.1 Kit Contents
   2. 2.2 Key Features
   3. 2.3 Component Identification
   4. 2.4 BoosterPacks
   5. 2.5 Compliance
   6. 2.6 Security
6. 3Board Setup
   1. 3.1 Power Requirements
      1. 3.1.1 Power Input Using USB Type-C Connector
      2. 3.1.2 Power Status LED's
      3. 3.1.3 Power Tree
      4. 3.1.4 Power Sequence
   2. 3.2 Push Buttons
   3. 3.3 Boot Mode Selection
7. 4Hardware Description
   1. 4.1  Functional Block Diagram
   2. 4.2  BoosterPack Headers
      1. 4.2.1 Pinmux for BoosterPack
   3. 4.3  GPIO Mapping
   4. 4.4  Reset
   5. 4.5  Clock
   6. 4.6  Memory Interface
      1. 4.6.1 QSPI Interface
      2. 4.6.2 Board ID EEPROM
   7. 4.7  Ethernet Interface
      1. 4.7.1 Ethernet PHY Strapping
      2. 4.7.2 Ethernet PHY - Power, Clock, Reset, Interrupt
      3. 4.7.3 LED indication in Ethernet RJ45 Connector
   8. 4.8  USB 2.0 Interface
   9. 4.9  I2C Interface
   10. 4.10 Industrial Application LEDs
   11. 4.11 UART Interface
   12. 4.12 eQEP Interface
   13. 4.13 CAN Interface
   14. 4.14 FSI Interface
   15. 4.15 JTAG Emulation
   16. 4.16 Test Automation Interface
   17. 4.17 SPI Interface
8. 5References
   1. 5.1 Reference Documents
   2. 5.2 Other TI Components Used in This Design
9.   A E3 Design Changes
10.   B Revision A Design Changes
11.   Revision History