SPRUJ22C
November 2021 – September 2024
AWR2944
1
Description
Features
4
1
Evaluation Module Overview
1.1
Introduction
1.2
Key Features
1.3
What’s Included
1.3.1
Kit Contents
1.3.2
mmWave Out-of-Box (OOB) Demo
2
Hardware
2.1
Block Diagram
2.2
PCB Handling Recommendations
2.3
Power Connections
2.4
Connectors
2.4.1
MIPI 60-Pin Connector (J19)
2.4.2
Debug Connector-60 pin (J7)
2.4.3
CAN-A Interface Connector (J3)
2.4.4
CAN-B Interface Connector (J2)
2.4.5
Ethernet Ports (J4 and J9)
2.4.5.1
ECOs to Enable the DP83TC812R (AWR2944EVM) or DP83TG720S (AWR2944PEVM) PHY
2.4.5.1.1
ECO needed to source 25MHz clock from AWR2944P to DP83TG720S
2.4.6
USB Connectors (J8, J10)
2.4.7
OSC_CLKOUT Connector (J14)
2.4.8
PMIC SPI Connector (J16) (DNP)
2.4.9
Voltage Rails Ripple Measurement Connectors (J1, J5) (DNP)
2.5
Antenna
2.6
PMIC
2.7
On-Board Sensors
2.8
PC Connection
2.8.1
XDS110 Interface
2.8.2
FTDI Interface
2.9
Connecting the AWR2944EVM/AWR2944PEVM to the DCA1000 EVM
2.10
Jumpers, Switches, and LEDs
2.10.1
Switches
2.10.2
Sense On Power (SOP) Jumpers (J17, J18, J20)
2.10.3
I2C Connections
2.10.4
Push Buttons
2.10.5
LEDs
3
Software
3.1
Software, Development Tools, and Example Code
4
Hardware Design Files
4.1
Design Files
5
Compliance Information
5.1
Requirements for Operating in the EU and UK regions
6
Additional Information
Trademarks
7
Revision History
2
Hardware
Note:
During operation, a minimum separation distance of 20 centimeters must be maintained between the user and the EVM.
Figure 2-1
AWR2944EVM Front View
Figure 2-2
AWR2944EVM Back View
Figure 2-3
AWR2944PEVM Front View
Figure 2-4
AWR2944PEVM Back View