SWRA682 December   2020 CC1310 , CC1312PSIP , CC1312R , CC1314R10 , CC1350 , CC1352P , CC1352P7 , CC1352R , CC1354P10 , CC1354R10

 

  1.   Trademarks
  2. 1 Introduction
  3. 2 Recommended Test Setup
  4. 3 Overrides
  5. 4 Find the Needed RX BW
  6. 5 How to Set the Deviation
  7. 6 Theoretical Sensitivity
  8. 7 Determine AGC_REF Level
  9. 8 Determine Anti-Aliasing BW
  10. 9 Determine PA Ramp Settings
  11. 10Intermediate Frequency (IF)
  12. 11LNA Ib Offset
  13. 12Sensitivity and Selection of Sync Word
  14. 13Narrowband
    1. 13.1 Frequency Offset Tolerance
    2. 13.2 Low Datarate
    3. 13.3 Phase Noise
  15. 14RSSI Offset

11 LNA Ib Offset

It is possible to improve sensitivity by up to 0.5 dB by increase the current in the LNA and thereby the total current consumption.

The LNA current can be set through the following override:

// Set LNA IB offset to 0xL
(uint32_t)0x000L8883,

where the maximum value for L is 0xF.

The RSSI offset may change when changing the LNA gain.