SWRA750 September 2022
This is a non-packet continuous transmission with either GFSK (BR), π/4-DQPSK (2-EDR) or 8DPSK (3-EDR).
Steps and the HCI commands to put the device in the constant TX mode are:
The parameters for the HCI_VS_DRPb_Tester_Con_TX are:
The HCI commands for Stopping continuous Tx mode are:
TX Stop :
Send_HCI_VS_Write_Hardware_Register 0xFF01, 0x20014044, 0x0010
Wait_HCI_Command_Complete_VS_Write_Hardware_Register_Event 5000, any, HCI_VS_Write_Hardware_Register, 0x00
Send_HCI_VS_Write_Hardware_Register 0xFF01, 0x20014048, 0x0014
Wait_HCI_Command_Complete_VS_Write_Hardware_Register_Event 5000, any, HCI_VS_Write_Hardware_Register, 0x00
Stop PN Generator:
Send_HCI_VS_Write_Hardware_Register 0xFF01, 0x2001900C, 0x0000
Wait_HCI_Command_Complete_VS_Write_Hardware_Register_Event 5000, any, HCI_VS_Write_Hardware_Register, 0x00