SWRU622A August   2024  – September 2024 AWRL1432 , AWRL6432 , IWRL1432 , IWRL6432 , IWRL6432AOP

 

  1.   1
  2.   Trademarks
  3. 1Introduction
  4. 2Basic Bootloader Flow
    1. 2.1 Programming Serial Data Flash Over UART (Bootloader Service)
    2. 2.2 Binary File Format
    3. 2.3 Flash Programming Sequence
    4. 2.4 Supported UART Commands/Response and Format
    5. 2.5 Flashing Sequence
    6. 2.6 ROM-Assisted Image Download Sequence
    7. 2.7 Booting Application Image
      1. 2.7.1 Booting From Serial Flash
      2. 2.7.2 Bootmode – SPI
      3. 2.7.3 Bootmode - UART
  5. 3Secondary Bootloader
    1. 3.1 SBL Execution Flow
      1. 3.1.1 Flash Memory Partitioning for SBL Execution
      2. 3.1.2 SBL Feature Modifications
      3. 3.1.3 SBL Development Considerations
  6. 4Warm Reset
    1. 4.1 Integrity Verification
    2. 4.2 LSTC/PBIST
    3. 4.3 Watchdog Timer
    4. 4.4 Reset-Triggered Flash Reload of Application
      1. 4.4.1 Hardware Solutions
        1. 4.4.1.1 PMIC I2C Messaging
        2. 4.4.1.2 External Watchdog Timer
        3. 4.4.1.3 External Voltage Monitoring or Voltage Supervisors
      2. 4.4.2 Software Solutions
        1. 4.4.2.1 Setting Boot Vector to 0x0
  7. 5Relevant Registers
    1. 5.1 Reset Registers
    2. 5.2 PC Registers
      1. 5.2.1 Addresses
  8. 6Revision History

4.4.1 Hardware Solutions

Multiple Hardware solutions exist to create a reload from Flash on a reset of the device. Two of which are listed below