SWRU630 December   2024

 

  1.   1
  2.   Description
  3.   Getting Started
  4.   Features
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Key Features
    3. 1.3 Kit Contents
    4. 1.4 Specification
    5. 1.5 Device Information
  6. 2Hardware
    1. 2.1  xWRL6844EVM Antenna
      1. 2.1.1 PCB Material
        1. 2.1.1.1 Transmitter and Receiver Virtual Array
    2. 2.2  EVM Mux Block Diagram
    3. 2.3  Switch Settings
    4. 2.4  Push Button Switches
    5. 2.5  LEDs
    6. 2.6  DC Input Jack
    7. 2.7  USB Connector
    8. 2.8  DCA1000 HD Connector
    9. 2.9  BoosterPack Connector for LaunchPad Connectivity
    10. 2.10 CAN-FD_B Connector
    11. 2.11 CAN-FD_A Connector
    12. 2.12 LIN-PHY Connector
    13. 2.13 I2C Connections
      1. 2.13.1 EEPROM
    14. 2.14 XDS110 Interface
    15. 2.15 FTDI Interface
    16. 2.16 DCA1000EVM Mode
    17. 2.17 PCB Storage and Handling Recommendations:
      1. 2.17.1 PCB Storage and Handling Recommendations
      2. 2.17.2 Higher Power Demanding Applications
  7. 3Software, Development Tools, and Example Code
  8. 4Hardware Design Files
    1. 4.1 Schematics, PCB Layout and Bill of Materials (BOM)
    2. 4.2 EVM Design Database
    3. 4.3 Hardware Design Checklist
  9. 5Additional Information
    1. 5.1 Trademarks
  10. 6References
    1. 6.1 TI E2E Community
  11. 7Revision History

2.15 FTDI Interface

J10 connector provides access to the onboard FTDI ports. This provides the following Interfaces to PC:

  • FTDI Port A : SPI
  • FTDI Port B : I2C, HOST_INTERRUPT
  • FTDI Port C : UARTA, nRESET
  • FTDI Port D : RS232, SOP control

When xWRL6844EVM's FTDI USB is connected for the first time to PC, Windows® may not be able to recognize the device. This is indicated and confirmed in the device manager with yellow exclamation marks, as shown in Figure 2-29.

AWRL6844EVM IWRL6844EVM Uninstalled FTDI Drivers Figure 2-29 Uninstalled FTDI Drivers

In order to correctly detect these ports on the PC please download and install the latest FTDI drivers available in the (C:\ti\mmwave_sdk_\tools\ftdi). This must be done for all four COM ports. When all four COM ports are installed, the device manager recognizes these devices and indicates the COM port numbers, as shown in Figure 2-30.

AWRL6844EVM IWRL6844EVM Installed FTDI Drivers Figure 2-30 Installed FTDI Drivers