TIDUF78 May   2024

 

  1.   1
  2.   Description
  3.   Resources
  4.   Features
  5.   Applications
  6.   Design Images
  7. 1System Description
    1. 1.1 Key System Specifications
  8. 2System Overview
    1. 2.1 Block Diagram
    2. 2.2 Design Considerations
    3. 2.3 Highlighted Products
  9. 3System Design Theory
    1. 3.1 Hardware Design
    2. 3.2 Software Design
      1. 3.2.1 TMAG5170 SPI Frame
        1. 3.2.1.1 Serial Data In 32-Bit Frame
        2. 3.2.1.2 Serial Data Out 32-Bit Frame
      2. 3.2.2 TMAG5170 Register Configuration
      3. 3.2.3 SPI and Start-of-Conversion Timing
      4. 3.2.4 Linear Position Calculation
  10. 4Hardware, Software, Testing Requirements, and Test Results
    1. 4.1 Hardware
      1. 4.1.1 PCB Overview
      2. 4.1.2 MCU Interface Connector
    2. 4.2 Test Setup
    3. 4.3 Test Results
      1. 4.3.1 Magnetic Z and X Field Measurement
      2. 4.3.2 Linear Position Measurement
      3. 4.3.3 SPI Signal Measurement
  11. 5Design and Documentation Support
    1. 5.1 Design Files
      1. 5.1.1 Schematics
      2. 5.1.2 BOM
      3. 5.1.3 PCB Layout
        1. 5.1.3.1 Layout Prints
        2. 5.1.3.2 Layout Guidelines
    2. 5.2 Tools and Software
    3. 5.3 Documentation Support
    4. 5.4 Support Resources
    5. 5.5 Trademarks
  12. 6About the Author

2.1 Block Diagram

The block diagram of this reference design is shown in Figure 2-1. A dedicated start of conversion pin (ALERT), enables simultaneous sampling of all 3D Hall-effect sensors by the host MCU and enables low jitter synchronization of the position sampling time with respect to the power stage and segment control algorithms.

TIDA-060045 System Block DiagramFigure 2-1 System Block Diagram