SLUAA12 March   2020 TPS53681

 

  1.   Selection Considerations for Output Capacitors of Multiphase Voltage Regulators Part 1
    1.     Trademarks
    2. 1 Introduction
    3. 2 Current Transfer Function Gii_CL(s) of Load Current to Inductor Current
    4. 3 Output Capacitance Calculation Based on Load Transient
      1. 3.1 Steady-state Output Ripple
      2. 3.2 Load Step Transient Response
        1. 3.2.1 Case 1: Small-signal Transient with Unsaturated Loop
        2. 3.2.2 Case 2: Large-signal Transient with Saturated Loop
        3. 3.2.3 Criteria for Loop Saturation
    5. 4 Analytical Calculations and Experimental Verification
    6. 5 Conclusions
    7. 6 References

Selection Considerations for Output Capacitors of Multiphase Voltage Regulators Part 1

This application note describes the selection considerations of output capacitors, based on load transient and output impedance of processors power rails. Presently, there are no specific tools available for non-Intel processor output capacitors selection in multiphase designs. In Part 1, the minimum required output capacitance to meet low repetitive rate load transient specifications is discussed. Part 2 will describe capacitor types and value to meet output impendence requirements, and also high rate repetitive load transient specifications. Analytical and experimental results show that output capacitors selection is optimized for load transient and output impedance, to fulfill non-Intel processor requirements.