The TPSI2140Q1EVM helps designers evaluate the operation and performance of the TPSI2140-Q1. This user's guide provides the connectors, test point descriptions, operational modes, schematic, bill of materials, and board layout of the EVM. The TPSI2140-Q1 is a 3.75-kVrms isolated switch. The inputs and output connections to the board are terminal blocks, which allow for easily wired connections. The TPSI2140Q1EVM contains multiple test points for monitoring the TPSI2140-Q1 functionality.
![]() |
|
|
![]() |
|
|
![]() |
|
|
![]() |
|
|
All trademarks are the property of their respective owners.
Always follow TI's set-up and application instructions, including use of all interface components within their recommended electrical rated voltage and power limits. Always use electrical safety precautions to help ensure your personal safety and those working around you. Contact TI's Product Information Center http://ti.com/customer support for further information.
Save all warnings and instructions for future reference.
Failure to follow warnings and instructions can result in personal injury, property damage or death due to electrical shock and burn hazards.
The term TI HV EVM refers to an electronic device typically provided as an open framed, unenclosed printed circuit board assembly. It is intended strictly for use in development laboratory environments, solely for qualified professional users having training, expertise and knowledge of electrical safety risks in development and application of high voltage electrical circuits. Any other use and/or application are strictly prohibited by Texas Instruments. If you are not suitably qualified, you should immediately stop from further use of the HV EVM.
As a precautionary measure, it is always good engineering practice to assume that the entire EVM may have fully accessible and active high voltages.
While the EVM is energized, never touch the EVM or its electrical circuits, as they could be at high voltages capable of causing electrical shock hazard.
Limitation for safe use:
EVMs are not to be used as all or part of a production unit.