SLASFK2 December   2024 DAC121S101-SEP

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics
    6. 5.6 Timing Requirements
    7. 5.7 Timing Diagram
    8. 5.8 Typical Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 DAC Section
      2. 6.3.2 Resistor String
      3. 6.3.3 Output Amplifier
    4. 6.4 Device Functional Modes
      1. 6.4.1 Power-On Reset
      2. 6.4.2 Power-Down Modes
    5. 6.5 Programming
      1. 6.5.1 Serial Interface
      2. 6.5.2 Input Shift Register
  8. 7 Application and Implementation
    1. 7.1 Application Information
      1. 7.1.1 Bipolar Operation
    2. 7.2 Typical Application
      1. 7.2.1 Design Requirements
      2. 7.2.2 Detailed Design Procedure
      3. 7.2.3 Application Curve
    3. 7.3 Power Supply Recommendations
    4. 7.4 Layout
      1. 7.4.1 Layout Guidelines
      2. 7.4.2 Layout Example
  9. 8 Device and Documentation Support
    1. 8.1 Documentation Support
    2. 8.2 Receiving Notification of Documentation Updates
    3. 8.3 Support Resources
    4. 8.4 Trademarks
    5. 8.5 Electrostatic Discharge Caution
    6. 8.6 Glossary
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

Package Options

Refer to the PDF data sheet for device specific package drawings

Mechanical Data (Package|Pins)
  • DGK|8
Thermal pad, mechanical data (Package|Pins)
Orderable Information

4 Pin Configuration and Functions

Figure 4-1 DAC121S101-SEP DGK Package, 8-Pin VSSOP (Top View)
Table 4-1 Pin Functions
PIN TYPE DESCRIPTION
NO. NAME
1 VA Power Power supply and reference input. Decouple to the GND pin.
2 NC — Solder this pin to a pad.
3 NC — Solder this pin to a pad.
4 VOUT Output DAC analog output voltage
5 SYNC Input Frame synchronization input for the data input. When this pin goes low, this pin enables the input shift register and data are transferred on the falling edges of SCLK. The DAC is updated on the 16th clock cycle unless SYNC is brought high before the 16th clock, in which case the rising edge of SYNC acts as an interrupt and the write sequence is ignored by the DAC.
6 SCLK Input Serial clock input. Data are clocked into the input shift register on the falling edges of this pin.
7 DIN Input Serial data input. Data are clocked into the 16-bit shift register on the falling edges of SCLK after the fall of SYNC.
8 GND Ground Ground reference for all on-chip circuitry.