SLLS822B July   2007  – July 2021 TRSF3221E

PRODUCTION DATA  

  1. Features
  2. Applications
  3. Description
  4. Revision History
  5. Pin Configuration and Functions
  6. Specifications
    1. 6.1  Absolute Maximum Ratings
    2. 6.2  ESD Ratings
    3. 6.3  ESD Ratings, IEC Specifications
    4. 6.4  Recommended Operating Conditions
    5. 6.5  Thermal Resistance Characteristics
    6. 6.6  Electrical Characteristics
    7. 6.7  Electrical Characteristics, Driver
    8. 6.8  Switching Characteristics, Driver
    9. 6.9  Electrical Characteristics, Receiver
    10. 6.10 Switching Characteristics, Receiver
    11. 6.11 Electrical Characteristics, Auto-Powerdown
    12. 6.12 Switching Characteristics, Auto-Powerdown
    13. 6.13 Typical Characteristics
  7. Parameter Measurement Information
  8. Detailed Description
    1. 8.1 Overview
    2. 8.2 Functional Block Diagram
    3. 8.3 Feature Description
    4. 8.4 Device Functional Modes
  9. Application and Implementation
    1. 9.1 Application Information
      1. 9.1.1 Typical Application
        1. 9.1.1.1 Design Requirements
        2. 9.1.1.2 Detailed Design Procedure
      2. 9.1.2 Application Performance Plot
  10. 10Power Supply Recommendations
  11. 11Layout
    1. 11.1 Layout Guidelines
    2. 11.2 Layout Example
  12. 12Device and Documentation Support
    1. 12.1 Receiving Notification of Documentation Updates
    2. 12.2 Support Resources
    3. 12.3 Trademarks
    4. 12.4 Electrostatic Discharge Caution
    5. 12.5 Glossary
  13. 13Mechanical, Packaging, and Orderable Information

Package Options

Mechanical Data (Package|Pins)
Thermal pad, mechanical data (Package|Pins)
Orderable Information

Typical Application

ROUT and DIN connect to UART or general purpose logic lines. FORCEON and FORCEOFFmay be connected general purpose logic lines or tied to ground or VCC. INVALID may be connected to a general purpose logic line or left unconnected. RIN and DOUT lines connect to a RS-232 connector or cable. DIN, FORCEON, and FORCEOFF inputs must not be left unconnected.
GUID-20200910-CA0I-SFX6-76PT-X05HHC8KVJ3J-low.gif
C3 can be connected to VCC or GND.
Resistor values shown are nominal.
Nonpolarized ceramic capacitors are acceptable. If polarized tantalum or electrolytic capacitors are used, they must be connected as shown.
Figure 9-1 Typical Operating Circuit and Capacitor Values
Table 9-1 VCC vs Capacitor Values
VCCC1C2, C3, C4
3.3 V ± 0.3 V0.1 µF0.1 µF
5 V ± 0.5 V0.047 µF0.33 µF
3 V to 5.5 V0.1 µF0.47 µF