Voltage at the EN pin controls the start-up or remote shutdown of the LMQ664x0-Q1 family of devices. The part stays shut down as long as the EN pin voltage is less than V_EN-WAKE = 0.7 V (typical). During the shutdown, the input current drawn by the device typically drops down to 0.25 µA (V_IN = 13.5 V). With the voltage at the EN pin greater than V_EN-WAKE, the device enters device standby mode and the internal LDO powers up to generate VCC. As the EN voltage increases further, approaching V_EN-VOUT, the device finally starts to switch, entering start-up mode with a soft start. During the device shutdown process, when the EN input voltage measures less than (V_EN-VOUT–V_EN-HYST), the regulator stops switching and re-enters device standby mode. Any further decrease in the EN pin voltage, below V_EN-WAKE, and the device is then firmly shut down. The high-voltage compliant EN input pin can be connected directly to the V_IN input pin if remote precision control is not needed. The EN input pin must not be allowed to float. The various EN threshold parameters and the values are listed in the Electrical Characteristics. Figure 7-2 shows the precision enable behavior and Figure 7-3 shows a typical remote EN start-up waveform in an application. After EN goes high, after a delay of about 2.5 ms, the output voltage begins to rise with a soft start and reaches close to the final value in about 3.5 ms (t_ss). After a delay of about 2.5 ms (t_{PG_ACT}), the PG flag goes high. During start-up, the device is not allowed to enter FPWM mode until the soft-start time has elapsed. This time is measured from the rising edge of EN. Check Section 8.2.1.2.9 for component selection.

Figure 7-1 VIN UVLO Using the EN Pin

Figure 7-2 Precision Enable Behavior

Figure 7-3 Enable Start-Up V_IN = 24 V, V_OUT = 3.3 V, I_OUT = 2 A