7.7.2 Typical Characteristics: VS = 5 V
Test conditions unless otherwise noted: VS+ = 5 V, VS– = 0 V, VOCM = open, VOUT = 2 Vpp, RF = 2 kΩ, RL = 2 kΩ Differential, G = 1 V/V, Single-Ended Input, Differential Output, Input and Output Referenced to mid-supply, TA = 25°C, unless otherwise noted.
Figure 34. Small-Signal Frequency Response
Figure 36. Large- and Small-signal Pulse Response
Figure 38. Differential Slew Rate vs VOUT Step
Figure 40. 10-kHz FFT On Audio Analyzer
Figure 42. Harmonic Distortion vs Output Voltage at 1 MHz
Figure 44. Harmonic Distortion vs Load at 1 MHz
Figure 46. Two-Tone, 2nd and 3rd Order Intermodulation
Distortion vs Frequency
Figure 48. Single-Ended Output Saturation Voltage vs Load Current
Figure 50. Frequency Response vs CLOAD
Figure 52. Rejection Ratio vs Frequency
Figure 54. Turnoff Time
Figure 56. Main Amplifier Differential Open-Loop Gain and Phase vs Frequency
Figure 58. VOCM Small-Signal Frequency Response
Figure 60. VOCM Input Impedance vs Frequency
Figure 62. Input Offset Current Temp Drift Histogram
Figure 64. Input Offset Voltage Histogram
Figure 66. Input Offset Voltage vs Temperature
Figure 35. Large-Signal Frequency Response
Figure 37. Single-Ended Slew Rate vs VOUT Step
Figure 39. Overdrive Recovery
Figure 41. Harmonic Distortion vs Frequency
Figure 43. Harmonic Distortion vs Gain at 1 MHz
Figure 45. Harmonic Distortion vs VOCM at 1 MHz
Figure 47. Single-Ended Output Voltage Swing vs Load Resistance
Figure 49. Main Amplifier Differential Output Impedance vs Frequency
Figure 51. RO vs CLOAD
Figure 53. Turnon Time
Figure 55. Input-referred Voltage Noise and Current Noise Spectral Density
Figure 57. Output Balance Error vs Frequency
Figure 59. VOCM Large- and Small Signal Pulse Response
Figure 61. Input Offset Current Histogram
Figure 63. Input Offset Current vs Temperature
Figure 65. Input Offset Voltage Temp Drift Histogram