TPS38700S-Q1 device comes
preprogrammed with the power up, power down sequences shown in Table 9-1.
NIRQ and NRST pins both require a pull up resistor in the range of 10 kΩ to 100 kΩ.
SDA and SCL lines require pull up resistors in the range of 10 kΩ.
The microcontroller is used to clear fault
interrupts reported through the NIRQ interrupt pin and the INT_SCR1 and
INT_SCR2 registers. The interrupt flags can only be cleared by the host
micrcontroller with a write-1-to-clear operation; interrupt flags are not
automatically cleared if the fault condition is no longer present.