Some applications have transients that place the device into dropout, especially with a device such as a high-current linear regulator. A typical application with these transient conditions can require setting V_IN ≤ (V_OUT + V_DO) to keep the device junction temperature within the specified operating range. A load transient or line transient with these conditions can place the device into dropout (for example, a load transient from 1A to 3A at 1A/µs when operating with a V_IN of 5.4V and a V_OUT of 5.0V).

The load transient saturates the error amplifier output stage when the gate of the pass transistor is driven as high as possible by the error amplifier, thus making the pass transistor function as a resistor from V_IN to V_OUT. The error amplifier response time to this load transient (I_OUT = 3A to 1A at 1A/µs) is limited because the error amplifier must first recover from saturation, and then place the pass transistor back into active mode. During recovery from the load transient, V_OUT overshoots because the pass transistor is functioning as a resistor from V_IN to V_OUT. If operating under these conditions, apply a higher dc load or increase the output capacitance to reduce the overshoot.