JAJSMY5A July   2024  – November 2024 TRF1108

PRODUCTION DATA  

  1.   1
  2. 1 特長
  3. 2 アプリケーション
  4. 3 概要
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics
    6. 5.6 Typical Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 AC-Coupled Configuration
      2. 6.3.2 DC-Coupled Configuration
    4. 6.4 Device Functional Modes
      1. 6.4.1 Power-Down Mode
  8. 7 Application and Implementation
    1. 7.1 Application Information
      1. 7.1.1 Thermal Considerations
    2. 7.2 Typical Application
      1. 7.2.1 RF DAC Buffer Amplifier
        1. 7.2.1.1 Design Requirements
        2. 7.2.1.2 Detailed Design Procedure
        3. 7.2.1.3 Application Curve
    3. 7.3 Power Supply Recommendations
      1. 7.3.1 Single-Supply Operation
      2. 7.3.2 Dual-Supply Operation
    4. 7.4 Layout
      1. 7.4.1 Layout Guidelines
      2. 7.4.2 Layout Example
  9. 8 Device and Documentation Support
    1. 8.1 Documentation Support
      1. 8.1.1 Related Documentation
    2. 8.2 ドキュメントの更新通知を受け取る方法
    3. 8.3 サポート・リソース
    4. 8.4 Trademarks
    5. 8.5 静電気放電に関する注意事項
    6. 8.6 用語集
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

パッケージ・オプション

デバイスごとのパッケージ図は、PDF版データシートをご参照ください。

メカニカル・データ（パッケージ｜ピン）
  • RPV|12
サーマルパッド・メカニカル・データ
発注情報

7.4.1 Layout Guidelines

The TRF1108 is a wide-band feedback amplifier with approximately 15.5dB to 18dB of gain (1GHz to 8GHz). When designing with a wide-band RF amplifier with relatively high gain, follow these printed-circuit-board (PCB) layout guidelines to maintain stability and optimized performance:

  • Use a multilayer board to maintain signal and power integrity, and thermal performance. The figures in the next section show an example of a good layout.
  • Route the RF input and output lines as grounded coplanar waveguide (GCPW) lines. For the second layer, use a continuous ground polygon below the RF traces, and continuous VSS polygon below the amplifier area.
  • Match the input differential lines in length to minimize phase imbalance.
  • Use small-footprint, passive components wherever possible.
  • Connect the ground and VSS planes on the top and internal layers with well-stitched vias.
  • Place a thermal via under the device that connects the top thermal pad with VSS planes in the inner layers of the PCB. Also, connect the thermal pad to the top layer VSS plane through the VSS pins for improved heat dissipation.