SLUUCT7C May   2023  – June 2024 BQ25756

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Device Information
    4. 1.4 General Texas Instruments High Voltage Evaluation (TI HV EMV) User Safety Guidelines
      1. 1.4.1 General Safety Information
  7. 2Hardware
    1. 2.1 Board Parameters
    2. 2.2 IO and Jumper Descriptions
    3. 2.3 Recommended Operating Conditions
    4. 2.4 Equipment
      1. 2.4.1 Equipment Set Up
      2. 2.4.2 Equipment - Using a CV Load
      3. 2.4.3 Equipment Setup - Using a CV Load
  8. 3Hardware Design Files
    1. 3.1 Schematic
    2. 3.2 PCB Layout
    3. 3.3 Bill of Materials
  9. 4Additional Information
    1. 4.1 Trademarks
  10. 5Revision History

5 Revision History

Changes from Revision B (August 2023) to Revision C (June 2024)

  • Changed the ACUV from 4.2V to 10VGo
  • Added VBAT_REG and IAC Sense Resistor to Default Board Setup table Go
  • Changed JP4 to Installed Go
  • Added 5mΩ as IAC sense resistor defaultGo
  • Updated BQstudio images to BQ25756 bqz fileGo
  • Changed 1000μF to 2000μFGo
  • Updated first page of schematicsGo
  • Updated R2 in Bill of Materials tableGo

Changes from Revision A (June 2023) to Revision B (August 2023)

  • Changed IC voltage range to the most currentGo
  • Added limits of the BQ25756 EVMGo
  • Changed IC voltage range to the most currentGo
  • Changed first sentence to emphasize and expand on the capabilities of BQ25756 Go
  • Changed BQ25758 to BQ25756Go
  • Changed output power to 400 WGo
  • Added information about using CV load in Equipment sectionGo

Changes from Revision * (May 2023) to Revision A (June 2023)

  • Added schematic and PCB Layout imagesGo
  • Changed Bill of Materials tableGo