SLUUCW3 October   2023 TPS62843

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Setup
      1. 2.1.1 Input/Output Connector Descriptions
      2. 2.1.2 Hardware Setup
    2. 2.2 Modifications
      1. 2.2.1 Input and Output Capacitors
      2. 2.2.2 Adjusting the Output Voltage
      3. 2.2.3 Loop Response Measurement
  9. 3Implementation Results
  10. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1. 5.1 Trademarks

Input/Output Connector Descriptions

Table 2-1 Input/Output Connectors
Input/OutputDescription
Jx1, Pin 1 and 2 – VINPositive input connection from the input supply for the EVM.
Jx1, Pin 3 and 4 – S+/S-Input voltage sense connections. Measure the input voltage at this point.
Jx1, Pin 5 and 6 – GNDInput return connection from the input supply for the EVM.
Jx2, Pin 1 and 2 – VOUTOutput voltage connection.
Jx2, Pin 3 and 4 – S+/S-Output voltage sense connections. Measure the output voltage at this point.
Jx2, Pin 5 and 6 – GNDOutput return connection.
JPx1 – ENEN pin input jumper. Place the supplied jumper across ON and EN to turn on the IC. Place the jumper across OFF and EN to turn off the IC.
Note:

To achieve a different output voltage, disconnect the power supply of the EVM. Replace the R11/R21/R31 accordingly (refer the data sheet), then power up the device again.