SLVUCL5 june   2023 TPS62874-Q1 , TPS62875-Q1 , TPS62876-Q1 , TPS62877-Q1

 

  1.   1
  2.   TPS62876EVM-199 Evaluation Module
  3.   Trademarks
  4. 1Warning and Caution
  5. 2Introduction
    1. 2.1 Performance Specification
    2. 2.2 Modifications
      1. 2.2.1 Input and Output Capacitors
      2. 2.2.2 Output Voltage Setting
      3. 2.2.3 Control Loop Compensation
      4. 2.2.4 Switching Frequency Setting
      5. 2.2.5 I2C Interface
  6. 3Setup
    1. 3.1 Connector Descriptions
    2. 3.2 Hardware Setup
  7. 4TPS62876EVM-199 Test Results
  8. 5Board Layout
  9. 6Schematic and Bill of Materials
    1. 6.1 Schematic
    2. 6.2 Bill of Materials

Connector Descriptions

MH1 – VINPositive input voltage connection from the input supply for the EVM
J1-1 – VINsense, J1-2 - GNDsenseInput voltage sense connections, measure the input voltage at this point
MH2 – GNDInput return connection from the input supply for the EVM
MH3 – VOUTPositive output voltage connection
JP8-1 – VOUTsense, JP8-2 - GNDsenseOutput voltage sense connections, measure the output voltage at this point
MH4 – GNDOutput return connection
JP1 – ENEN pin jumper. Place the supplied jumper across ON and EN to turn on the IC. Place the jumper across OFF and EN to turn off the IC.
JP2 – MODE/SYNCMODE/SYNC pin jumper. Place the supplied jumper across VIN and MODE/SYNC to force the device in fixed frequency PWM operation at all load currents. Place the jumper across MODE/SYNC and GND to enable power save mode. Connect a clock signal to MODE/SYNC referenced to GND to synchronize the switching frequency to the clock signal.
JP3 – PGThe PG output appears on pin 1 of this header with a convenient ground on pin 2.
JP4 – SYNC_OUTAt the SYNC_OUT output the switching frequency is provided at pin 1 with a convenient ground on pin 2.
J5 – I2CI2C connection configured for being used with the USB2ANY interface.