SNLU226B February   2018  – April 2021 DS90UB960-Q1

 

  1. 1 Introduction
  2. 2 Features
  3. 3 Application Diagram
  4. 4 Major Components
  5. 5 Quick Start Guide
  6. 6 Board Connections
    1. 6.1 Power Supply
    2. 6.2 Power Over Coax Interface
    3. 6.3 MIPI CSI-2 Output Signals
    4. 6.4 FPD-Link III Signals
    5. 6.5 I2C Interface
    6. 6.6 Control Interface
  7. 7 Enable and Reset
  8. 8 ALP Software Setup
    1. 8.1  System Requirements
    2. 8.2  Download Contents
    3. 8.3  Installation of the ALP Software
    4. 8.4  Startup - Software Description
    5. 8.5  Information Tab
    6. 8.6  Registers Tab
    7. 8.7  Registers Tab - Address 0x00 Selected
    8. 8.8  Registers Tab - Address 0x00 Expanded
    9. 8.9  Scripting Tab
    10. 8.10 Sample ALP Python Script
      1. 8.10.1 Initialization
  9. 9 Troubleshooting ALP Software
    1. 9.1 ALP Loads the Incorrect Profile
    2. 9.2 ALP does not detect the EVM
  10. 10Typical Connection and Test Equipment
  11. 11Termination Device
  12. 12Typical Test Setup
  13. 13Equipment References
  14. 14Cable References
  15. 15Bill of Materials
  16. 16PCB Schematics
  17. 17Board Layout
  18. 18Revision History

18 Revision History

Changes from Revision A (March 2018) to Revision B (April 2021)

  • Updated Abstract section to include V3Link TDES960Go

Changes from Revision * (February 2018) to Revision A (March 2018)

  • Changed advance information to production dataGo
  • Added a note to update PoC filters when interfacing to DS90UB913A-Q1 and DS90UB933-Q1 serializers. Go
  • Added Figure 6-2 Go
  • Added Table 6-2 Go
  • Updated Bill of MaterialsGo
  • Updated PCB SchematicsGo
  • Updated Board LayoutGo