SNLU342 December   2023 MCT8315Z

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Quick Startup Guide
    2. 2.2 Hardware Setup
    3. 2.3 Hardware Connections Overview
    4. 2.4 Connection Details
    5. 2.5 MSP430FR2355 Microcontroller
    6. 2.6 LED Lights
    7. 2.7 User-Configurable Settings
      1. 2.7.1 Hardware Variant Resistor Settings
      2. 2.7.2 SPI Variant Resistor Settings
  9. 3Software
    1. 3.1 Firmware and GUI Application
    2. 3.2 MCT8315Z GUI
    3. 3.3 Running the GUI
    4. 3.4 Downloading Code Composer Studio and Importing GUI Firmware
    5. 3.5 Using the eZ-FET to Program the MSP430FR2355
  10. 4Hardware Design Files
    1. 4.1 Schematics
      1. 4.1.1 MCT8315Z 3-Phase Sensored Trapezoidal Motor Driver
      2. 4.1.2 Power Supplies
      3. 4.1.3 MCU Interface
      4. 4.1.4 User Interface
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1.     Trademarks

2.2 Hardware Setup

The hardware required to run a motor is the MCT8315ZEVM, a micro-USB cable, and a power supply with a DC output from 4.5 V to 35 V. Follow these steps to start up the MCT8315ZEVM:

  1. Connect the DC power supply to header J7. Connect to VBAT and PGND to apply reverse polarity protection and the Pi filter to the EVM. Otherwise, connect to VM and PGND to bypass the reverse polarity protection and Pi filter.

  2. If using the MCT8315ZH or MCT8315ZT, populate the desired resistor settings in the “HW Variant Resistors” silk screen box, see Table 3-4. If using the MCT8315ZR populate the resistors R13-R16 in the "Pop. If SPI" silk screen box.

  3. Apply user-configurable jumper settings. See the Section 2.7 section for more information.
  4. Flash the program into the MCU as described in Section 3.1. Launch the GUI in GUI Composer and disconnect the 4-pin JTAG connections.
  5. Connect a micro-USB cable to the MCT8315ZEVM and computer.
  6. Turn on the power supply and power up the PCB.

If using the MCT8315ZEVM with an external microcontroller, remove all shunt jumpers from jumper bridge J6. Connect with external jumpers to the left side of the jumper bridge from the external MCU.