SNVU785C February   2022  – August 2024 TPS389006-Q1

 

  1.   1
  2.   Trademarks
  3. 1Introduction
    1. 1.1 Related Documentation
    2. 1.2 TPS389006-Q1 Applications
  4. 2Schematic, Bill of Materials, and Layout
    1. 2.1 TPS389006Q1EVM Schematic
    2. 2.2 TPS389006Q1EVM Bill of Materials
    3. 2.3 Layout and Component Placement
    4. 2.4 Layout
  5. 3EVM Connectors
    1. 3.1 EVM Test Points
    2. 3.2 EVM Jumpers
  6. 4EVM Setup and Operation
    1. 4.1 Setup and GUI Installations
      1. 4.1.1 TPS389006Q1EVM Hardware Setup
      2. 4.1.2 TPS389006Q1EVM Software Setup
    2. 4.2 Quick Start to TPS389006Q1EVM GUI
    3. 4.3 Example Operation of TPS389xxx-Q1
  7. 5Revision History

2.3 Layout and Component Placement

Figure 2-3 and Figure 2-4 show the top and bottom assemblies of the printed circuit board (PCB) to show the component placement on the EVM.

Figure 2-5 and Figure 2-6 show the top and bottom layouts, Figure 2-7 and Figure 2-8 show the top and bottom layers, and Figure 2-9 and Figure 2-10 shows the top and bottom solder masks of the EVM.