SNVU868A September   2023  – April 2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Setup
    2. 2.2 Jumper Information
    3. 2.3 Power Supply
  9. 3Software
    1. 3.1 Software Description
    2. 3.2 GUI Installation
    3. 3.3 Graphical User Interface (GUI) Guidance
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1. 5.1 Trademarks
  12. 6Revision History

2.1 Setup

This section describes how to set up the LP5813-12EVM properly. Items from the following list are required to begin evaluating the LP5813/LP5812:

  • Computer
  • LP5813-12EVM
  • USB2ANY interface adapter

In the default jumper setting, the board can be evaluated by USB2ANY power directly and does not need an external power supply. Setup connection is demonstrated in Figure 3-1. The setup procedure is as follows:

  1. Connect the USB2ANY with the LP5813-12EVM using the ribbon cable.
  2. Make sure all jumpers are properly set under the appropriate operating conditions. See more details in Jumper Information.
  3. Plug the USB cable into the USB port on the computer.
GUID-20230712-SS0I-HNZ1-2QXH-NZ9S66MV6GX6-low.png Figure 2-1 Hardware Connection