DLPU058A September   2017  – February  2019 DLP3010 , DLPA3000 , DLPC3433 , DLPC3438

 

  1.   DLP® LightCrafter Display 3010 EVM Gen2 User's Guide
    1.     Trademarks
    2. 1 DLP® LightCrafter™ Display 3010 EVM Gen2 Overview
    3. 2 Safety Instructions
    4. 3 Applicable Documents
    5. 4 What is in the DLP LightCrafter Display 3010 EVM?
    6. 5 Light Engine
    7. 6 Quick-Start Procedure
    8. 7 Circuit Description
      1. 7.1 Connectors and Switches on Main Board
      2. 7.2 Connectors on DLP LightCrafter Display Board
    9. 8 EVM Setup
  2.   Revision History

8 EVM Setup

The DLP LightCrafter Display 3010 EVM-G2 is composed of three parts:

  • Main board
  • DLP LightCrafter Display board
  • Engine with LED connection and Flex cable

The main board contains the connector for the power supply, a USB connector to communicate to the DLP LightCrafter Display software, HDMI and the connector for the DLP LightCrafter Display board. The main board also contains a switch to turn on the projector in case the DLP LightCrafter Display board and the engine are connected. Figure 5 shows the main connectors on the main board.

DLP3010 DLP002_MainBoard.jpgFigure 5. DLP LightCrafter Display Main Board

The DLP LightCrafter Display board contains the RGB LED connectors, the Flex cable connector, and the main board connector. To connect the main board to the DLP LightCrafter Display board, refer to Figure 6. Note that the main board connector on the DLP LightCrafter Display board is on the bottom, while the LED and Flex cable connectors are on the top.

DLP3010 DLP002_Connector_MainBoard.jpgFigure 6. Connection Main Board and DLP LightCrafter Display Board

Figure 7 shows the display board and how it connects to the main board. The different connectors for each LED are named on the board as well as on the light engine.

DLP3010 DLP002_Flex_LED_connector.jpgFigure 7. DLP LightCrafter Display EVM

Ensure a good connection of the flex cable and LED cables to the DLP LightCrafter Display board before turning it on.