SBAU206B april   2015  – may 2023 ADS1262 , ADS1263

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1EVM Overview
    1. 1.1 ADS1263EVM Kit
    2. 1.2 ADS1263EVM Board
  5. 2Getting Started With the ADS1263EVM
  6. 3Analog Interface
    1. 3.1 Analog Input Options
      1. 3.1.1 ADS1263 Integrated Input Functions
        1. 3.1.1.1 ADC Inputs
        2. 3.1.1.2 IDAC Output
        3. 3.1.1.3 VBIAS Output
        4. 3.1.1.4 External Reference
        5. 3.1.1.5 Test DAC Output
        6. 3.1.1.6 GPIO
      2. 3.1.2 Analog Sensor Connections
        1. 3.1.2.1 Connecting a Thermocouple to J4 on the ADS1263EVM
        2. 3.1.2.2 Connecting a Thermistor to J3 on the ADS1263EVM
        3. 3.1.2.3 Using Thermistor RT1 for Thermocouple Cold-Junction Compensation
        4. 3.1.2.4 Connecting an RTD to J3 on the ADS1263EVM
          1. 3.1.2.4.1 Connecting a 2-Wire RTD
          2. 3.1.2.4.2 Connecting a 3-Wire RTD
          3. 3.1.2.4.3 Connecting a 4-Wire RTD
    2. 3.2 ADC Connections and Decoupling
    3. 3.3 Clocking
    4. 3.4 Voltage Reference
  7. 4Digital Interface
  8. 5Power Supplies
  9. 6Software Installation
  10. 7EVM Operation and GUI
    1. 7.1 Connecting the EVM Hardware
    2. 7.2 EVM GUI Global Settings for ADC Control
    3. 7.3 Time Domain Display
    4. 7.4 Frequency Domain Display
    5. 7.5 Histogram Display
    6. 7.6 Using the GUI to Control ADC2
  11. 8Bill of Materials, PCB Layout, and Schematics
    1. 8.1 Bill of Materials
    2. 8.2 PCB Layout
    3. 8.3 Schematics
  12. 9Revision History

7.2 EVM GUI Global Settings for ADC Control

Figure 7-3 shows that the EVM global controls are located on the left side of the GUI. These controls include the filter type, data rate, PGA gain, input channels, number of samples, and others. The Pages control in the upper-left allows access to the other pages in the GUI. Figure 7-3 also shows the ADC register settings. The registers can be used to set the different device modes such as power, PGA, and ADC selection. Change the register settings by clicking on each bit, typing a value directly into the Value column, or by selecting from the drop-down menus in the Field View control.

GUID-20220719-SS0I-KQX5-9TMK-NDSX1XM3SZ6K-low.pngFigure 7-3 ADS1263EVM GUI Global Settings for the ADC Control Page