SBOSAA3A July   2024  – November 2024 TRF1108

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics
    6. 5.6 Typical Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 AC-Coupled Configuration
      2. 6.3.2 DC-Coupled Configuration
    4. 6.4 Device Functional Modes
      1. 6.4.1 Power-Down Mode
  8. 7 Application and Implementation
    1. 7.1 Application Information
      1. 7.1.1 Thermal Considerations
    2. 7.2 Typical Application
      1. 7.2.1 RF DAC Buffer Amplifier
        1. 7.2.1.1 Design Requirements
        2. 7.2.1.2 Detailed Design Procedure
        3. 7.2.1.3 Application Curve
    3. 7.3 Power Supply Recommendations
      1. 7.3.1 Single-Supply Operation
      2. 7.3.2 Dual-Supply Operation
    4. 7.4 Layout
      1. 7.4.1 Layout Guidelines
      2. 7.4.2 Layout Example
  9. 8 Device and Documentation Support
    1. 8.1 Documentation Support
      1. 8.1.1 Related Documentation
    2. 8.2 Receiving Notification of Documentation Updates
    3. 8.3 Support Resources
    4. 8.4 Trademarks
    5. 8.5 Electrostatic Discharge Caution
    6. 8.6 Glossary
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

7.3.1 Single-Supply Operation

The TRF1108 supports single 5V supply operation for ac-coupled applications. Supply decoupling is critical to high-frequency performance. Typically, two or three capacitors are used for VDD supply decoupling. Use a 220nF, small-form-factor, 0201-size component placed closest to the VDD pin of the device. Use 0402-size, 2.2μF bulk decoupling capacitors placed next to the small capacitor. A ferrite bead can be further used to filter power-supply noise. For single-supply operation, short VSS to RF ground; a separate VSS plane is not needed. See also Section 7.4.