SBOU297A April   2024  – July 2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Additional Images
    2. 2.2 How to Setup
    3. 2.3 Assembly Instructions
    4. 2.4 Power Requirements
    5. 2.5 Setup
    6. 2.6 Header Information
    7. 2.7 Interfaces
    8. 2.8 Best Practices
  8. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  9. 4Additional Information
    1. 4.1 Trademarks
  10. 5Revision History

2.3 Assembly Instructions

For best practice, follow the recommended assembly procedure:

  1. Find which preconfigured circuit or pin-to-pin circuit is most appropriate. Common op amp parameter setups are described in detail in Section 2.5.
  2. Install daughtercard onto the selected circuit on AMP-PDK-EVM by aligning both black headers and the alignment metal guide. Apply equal pressure to all four corners of the daughtercard until securely in place.
  3. Using ESD safety precautions, place device into the socket with pin 1 alignment. If needed, then reference pin 1 alignment for all daughtercards in Section 2.7.
  4. Connect power to the board, this is discussed in further detail in Section 2.4.
  5. Connect input and output equipment to the surface mount test points, this is discussed in further detail in the Section 2.6. Common op amp parameter tests setups can be found in Section 2.5.