For best practice, follow the recommended assembly procedure:
- Find which preconfigured circuit or pin-to-pin
circuit is most appropriate. Common op amp parameter setups are described in detail in
Section 2.5.
- Install daughtercard onto the selected circuit on
AMP-PDK-EVM by aligning both black headers and the alignment metal guide. Apply equal
pressure to all four corners of the daughtercard until securely in place.
- Using ESD safety
precautions, place device into the socket with pin 1 alignment. If needed, then
reference pin 1 alignment for all daughtercards in Section 2.7.
- Connect power to the board, this is discussed in
further detail in Section 2.4.
- Connect input and output equipment to the surface
mount test points, this is discussed in further detail in the Section 2.6. Common op amp parameter tests setups
can be found in Section 2.5.