SCDU037 May   2024 TMUXHS4612

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Setup and Configuration
      1. 2.1.1 Power
      2. 2.1.2 Jumper Configuration
      3. 2.1.3 Signal Connection
      4. 2.1.4 Optional Termination Resistors
      5. 2.1.5 Calibration Trace
    2. 2.2 Get Started
  8. 3Hardware Design Files
    1. 3.1 Schematic
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials
  9. 4Additional Information
    1. 4.1 Trademarks

2.2 Get Started

  1. Place a jumper across pins 2 and 3 on JMP8 to enable the device.
  2. Enable the channel the is being used.
    1. Place a jumper across pins 1 and 2 on JMP1 and JMP2 to enable channel A.
    2. Place a jumper across pins 2 and 3 on JMP1 and JMP2 to enable channel B.
  3. Power the board using the 3.3V and GND reference banana plugs.
  4. See signal pass through the mux.