SLAZ742A July   2023  – October 2023 MSPM0G1105 , MSPM0G1106 , MSPM0G1107 , MSPM0G1505 , MSPM0G1506 , MSPM0G1507 , MSPM0G3105 , MSPM0G3105-Q1 , MSPM0G3106 , MSPM0G3106-Q1 , MSPM0G3107 , MSPM0G3107-Q1 , MSPM0G3505 , MSPM0G3505-Q1 , MSPM0G3506 , MSPM0G3506-Q1 , MSPM0G3507 , MSPM0G3507-Q1

 

  1.   1
  2.   Abstract
  3. 1Functional Advisories
  4. 2Preprogrammed Software Advisories
  5. 3Debug Only Advisories
  6. 4Fixed by Compiler Advisories
  7. 5Device Nomenclature
  8. 6Advisory Descriptions
    1. 6.1  ADC_ERR_01
    2. 6.2  ADC_ERR_02
    3. 6.3  BSL_ERR_01
    4. 6.4  COMP_ERR_02
    5. 6.5  COMP_ERR_03
    6. 6.6  CPU_ERR_01
    7. 6.7  GPIO_ERR_01
    8. 6.8  I2C_ERR_01
    9. 6.9  I2C_ERR_02
    10. 6.10 I2C_ERR_03
    11. 6.11 PWREN_ERR_01
    12. 6.12 RTC_ERR_01
    13. 6.13 SPI_ERR_01
    14. 6.14 SPI_ERR_02
    15. 6.15 SYSOSC_ERR_01
    16. 6.16 TIMER_ERR_01
    17. 6.17 VREF_ERR_01
    18. 6.18 WWDT_ERR_01
    19. 6.19 WWDT_ERR_02
  9. 7Revision History

TIMER_ERR_01

Capture mode captures incorrect value when using hardware event to start timer

Revisions Affected

B

Details

When using any timer instance in capture mode, starting the timer using a zero (ZCOND) or load (LCOND) condition causes the timer to capture the zero or load value instead of the captured value in the respective TIMx.CC register. This affects periodic use cases such as period and pulse width capture.

Workaround

Use the below software flow to calculate the period or pulse width. See the timx_timer_mode_capture_duty_and_period in the MSPM0-SDK for an example of the workaround.

  • Disable ZCOND or LCOND by setting to 0h.
  • When a capture occurs, the capture value is correctly captured in TIMx.CC
  • Restart the timer by setting TIMx.CTR to the reload value (load or 0)