SLUUCQ6 December   2022 TPS92629-Q1

 

  1.   Abstract
  2.   Trademarks
  3. 1Introduction
    1. 1.1 Features
    2. 1.2 Typical Application
  4. 2TPS92629Q1EVM Description
    1. 2.1 Connector Map
    2. 2.2 Jumper Map
  5. 3Test Setup
  6. 4Schematic, Bill of Materials, and Layout
    1. 4.1 Schematics
    2. 4.2 Layout
  7. 5Bill of Materials (BOM)

2.1 Connector Map

The EVM has the following connectors. Table 2-1 shows their functions.

Table 2-1 Connector Map
ConnectorDescription
VBATThis connector is a power supply input.
GNDThis connector is a device part ground.

VBAT+

SUPPLY. This connector shows the positive input supply voltage.
EN/PWM

EN/PWM. This connector shows a device enable input and PWM input.

DIAGEN

DIAGEN. This connector shows the LED open dagnotics enable inout.

ADIM

ADIM. This connector shows a device PWM input for analog dimming.

FAULT

Fault. This connector is the FAULT status output of the LED driver.

Mult_FAULT

Mult_Fault.This connector is the multi fault status output of the LED driver.

OUT

This connector shows the output voltage.