SLUUD40 July   2024 TPSM82813 , TPSM82816

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  6. 2Hardware
    1. 2.1 Safety Instructions
    2. 2.2 Header Information
    3. 2.3 Jumper Information
    4. 2.4 Test Points
  7. 3Implementation Results
    1. 3.1 Performance Data and Results
    2. 3.2 Modifications
      1. 3.2.1 Input and Output Capacitors
      2. 3.2.2 Switching Frequency, Spread Spectrum and Control Loop Compensation
      3. 3.2.3 Soft-Start Time
      4. 3.2.4 Loop Response Measurement
      5. 3.2.5 Precise Turn-on Voltage
  8. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 Board Layout
    3. 4.3 Bill of Materials
  9. 5Additional Information
    1. 5.1 Trademarks

Loop Response Measurement

The loop response can be measured by adding a 50Ω resistor between VOUT and R1/C6. Figure 4-3 and Figure 4-4 show the results of this test.