SLVUBX4A November   2020  – February 2022 LP8764-Q1

 

  1.   Trademarks
  2. 1Introduction
  3. 2Getting Started
    1. 2.1 Getting Started: Single EVM
    2. 2.2 Getting Started: Multiple EVM Evaluation
    3. 2.3 GUI Tool
  4. 3EVM Details
    1. 3.1 Terminal Blocks
    2. 3.2 Test Point Descriptions
    3. 3.3 Configuration Headers
    4. 3.4 Stack-up Headers
    5. 3.5 Connectors
    6. 3.6 Dip Switches
    7. 3.7 EVM Control and GPIO
  5. 4Customization
    1. 4.1 Changing the Communication Interface
    2. 4.2 Changing the Phase Configuration
  6. 5Schematic, Layout, and Bill of Materials
  7. 6Additional Resources
  8. 7Revision History

2 Getting Started

Only a power supply and the EVM are required to evaluate and test the LP8764x-Q1 default configuration under load conditions. This section contains the controller and controller+target configurations and how to run these two default configurations.