SNLU226B February   2018  – April 2021 DS90UB960-Q1

 

  1. Introduction
  2. Features
  3. Application Diagram
  4. Major Components
  5. Quick Start Guide
  6. Board Connections
    1. 6.1 Power Supply
    2. 6.2 Power Over Coax Interface
    3. 6.3 MIPI CSI-2 Output Signals
    4. 6.4 FPD-Link III Signals
    5. 6.5 I2C Interface
    6. 6.6 Control Interface
  7. Enable and Reset
  8. ALP Software Setup
    1. 8.1  System Requirements
    2. 8.2  Download Contents
    3. 8.3  Installation of the ALP Software
    4. 8.4  Startup - Software Description
    5. 8.5  Information Tab
    6. 8.6  Registers Tab
    7. 8.7  Registers Tab - Address 0x00 Selected
    8. 8.8  Registers Tab - Address 0x00 Expanded
    9. 8.9  Scripting Tab
    10. 8.10 Sample ALP Python Script
      1. 8.10.1 Initialization
  9. Troubleshooting ALP Software
    1. 9.1 ALP Loads the Incorrect Profile
    2. 9.2 ALP does not detect the EVM
  10. 10Typical Connection and Test Equipment
  11. 11Termination Device
  12. 12Typical Test Setup
  13. 13Equipment References
  14. 14Cable References
  15. 15Bill of Materials
  16. 16PCB Schematics
  17. 17Board Layout
  18. 18Revision History

Startup - Software Description

Make sure all the software has been installed and the hardware is powered on and connected to the PC. Execute “Analog LaunchPAD” shortcut from the start menu. The default start menu location is under All Programs > Texas Instruments > Analog LaunchPAD vx.x.x > Analog LaunchPAD to start MainGUI.exe.

GUID-F128EDD4-09E2-458E-8ADB-692AD3FAE3DD-low.pngFigure 8-1 Launching ALP

The application must come up in the state shown in Figure 8-2. If it does not, see Section 9, “Troubleshooting ALP Software”.

Under the Devices tab click on “DS90UB960” or "DS90UB960_ENG" to select the device and open up the device profile and its associated tabs.

GUID-8638669D-7E20-4C6E-981B-59E456696762-low.pngFigure 8-2 Initial ALP Screen

After selecting the “DS90UB960” or "DS90UB960_ENG", the following screen shown in Figure 8-3 must appear provided four camera modules with DS90UB953-Q1 are connected to the EVM.

GUID-076550C2-F269-4399-95C9-6625F00390FC-low.pngFigure 8-3 Follow-up Screen