SNOA475F October   2016  – September 2020 LMV791

 

  1.   Trademarks
  2. 1Introduction
  3. 2What Parameters Should Be Tested?
    1. 2.1  Open-Loop Gain (AOL) and Phase Margin
    2. 2.2  Slew Rate
    3. 2.3  Common-Mode Rejection Ratio (CMRR) and Power Supply Rejection Ratio (PSRR)
    4. 2.4  Open-Loop Output Impedance (Zo)
    5. 2.5  Voltage Noise (en)
    6. 2.6  Current Noise (in)
    7. 2.7  Input Offset Voltage (VOS), Input Bias Current (Ib), and Quiescent Current (IQ)
    8. 2.8  Output Voltage Versus Output Current (Claw Curve)
    9. 2.9  Overload Recovery Time (tOR)
    10. 2.10 Common-mode Input Capacitance (CCM) and Common-mode Differential Capacitance (CDIFF)
    11. 2.11 Overshoot and Transient Response
    12. 2.12 Common-Mode Voltage Range (CMVR)
  4. 3Conclusion
  5.   Revision History

Revision History

Changes from Revision E (May 2020) to Revision F (September 2020)

  • Throughout this document, paragraphs were edited for conciseness, part numbers updated to reflect current portfolio, and simulation outputs added to confirm data sheet results and also to show examples for simulation circuits.Go

Changes from Revision D (November 2006) to Revision E (May 2020)

  • Changed Voltage Noise (en) Test Circuit imageGo