SWRU613A July   2023  – August 2024 AWRL1432 , IWRL1432

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1  XWRL1432BOOST Antenna
      1. 2.1.1 PCB Material
        1. 2.1.1.1 Transmitter and Receiver Virtual Array
    2. 2.2  EVM Mux Block Diagram
    3. 2.3  Switch Settings
    4. 2.4  LEDs
    5. 2.5  Connectors
    6. 2.6  USB Connector
    7. 2.7  DCA1000 HD Connector
    8. 2.8  Booster Pack Connector for the LaunchPad Connectivity
    9. 2.9  CANFD Connector
    10. 2.10 LIN PHY Connection
    11. 2.11 I2C Connections
      1. 2.11.1 EEPROM
    12. 2.12 XDS110 Interface
    13. 2.13 Flashing the Board
    14. 2.14 DCA1000EVM Mode
      1. 2.14.1 RDIF Interface for Raw ADC Capture
    15. 2.15 PCB Storage and Handling Recommendations:
      1. 2.15.1 PCB Storage and Handling Recommendations
      2. 2.15.2 Higher Power Demanding Applications
  8. 3Software
    1. 3.1 Software, Development Tools, and Example Code
      1. 3.1.1 XWRL1432 Demo Visualization Getting Started
  9. 4Hardware Design Files
    1. 4.1 Schematics, PCB Layout and Bill of Materials (BOM)
    2. 4.2 EVM Design Database
  10. 5Additional Information
    1. 5.1 Trademarks
  11. 6References
    1. 6.1 TI E2E Community
  12. 7Revision History

7 Revision History

Changes from Revision * (July 2023) to Revision A (August 2024)

  • Updated description of the Introduction sectionGo
  • Added information on Rogers RO4835LoPro material based antennas used in XWRL1432BOOST Antenna sectionGo
  • Updated description about transmitter antennas placement in Transmitter and Receiver Virtual Array sectionGo
  • Updated description in EVM Mux Block Diagram sectionGo
  • Updated description and Removed SOP Switches table in Switch Settings sectionGo
  • Added Switch settings table and SOP configuration table in Switch Settings sectionGo
  • Updated DCA1000 images to show correct Debug Mode Pin settings in DCA1000EVM Mode sectionGo
  • Added mmWave-L-SDK link to the description in Software, Development Tools, and Example Code sectionGo
  • Added prerequisites and steps for getting started in XWRL1432 Demo Visualization Getting Started sectionGo