DLPA073A September 2016 – September 2016 DLP2010 , DLPC2607 , DLPC3430 , DLPC3435
An existing DLP projection engine can be used in an AM-HUD design. The key specifications for projection units are brightness, throw ratio, resolution and minimum focus distance. In this section, these values are calculated.
Brightness
The total light output from a projector is measured in lumens. The following factors need to be considered in estimating the required light output from the projector:
The aspect ratio of the HUD image in this example is 12:6 and the suggested DLP panel (WVGA) has an aspect ratio of 16:9. The resulting HUD image is formed by a subset of the panel's available area, according to the following equation:
Throw Ratio
The following equations can be used to calculate distance between projection unit and combiner:
Projection unit specification is shown in Table 4: