전원 관리 AC/DC 및 DC/DC 컨버터(통합 FET)

TPS62827A

활성

2.4V~5.5V 입력, 4A 스텝다운 컨버터 - 강제 PWM, 1.5mm × 1.5mm VSON-HR 패키지

제품 상세 정보

Rating Catalog Operating temperature range (°C) -40 to 125 Topology Buck Type Converter Iout (max) (A) 4 Vin (min) (V) 2.4 Vin (max) (V) 5.5 Switching frequency (min) (kHz) 2200 Switching frequency (max) (kHz) 2200 Features Enable, Forced PWM, Light Load Efficiency, Output discharge, Over Current Protection, Power good, Pre-Bias Start-Up, Soft Start Fixed, Synchronous Rectification, UVLO Fixed, UVLO fixed Control mode Constant on-time (COT), DCS-Control Vout (min) (V) 0.6 Vout (max) (V) 4 Iq (typ) (µA) 4 Duty cycle (max) (%) 100
Rating Catalog Operating temperature range (°C) -40 to 125 Topology Buck Type Converter Iout (max) (A) 4 Vin (min) (V) 2.4 Vin (max) (V) 5.5 Switching frequency (min) (kHz) 2200 Switching frequency (max) (kHz) 2200 Features Enable, Forced PWM, Light Load Efficiency, Output discharge, Over Current Protection, Power good, Pre-Bias Start-Up, Soft Start Fixed, Synchronous Rectification, UVLO Fixed, UVLO fixed Control mode Constant on-time (COT), DCS-Control Vout (min) (V) 0.6 Vout (max) (V) 4 Iq (typ) (µA) 4 Duty cycle (max) (%) 100
VSON-HR (DMQ) 6 2.25 mm² 1.5 x 1.5
  • Available as an integrated-inductor power module: TPSM82821, TPSM82822, and TPSM82823
  • DCS-Control topology
  • 1% feedback or output voltage accuracy (full temperature range)
  • Up to 97% efficiency
  • 26mΩ and 25mΩ internal power MOSFETs
  • 2.4V to 5.5V input voltage range
  • 4µA operating quiescent current
  • 2.2MHz switching frequency
  • 0.6V to 4V adjustable output voltage
  • Power save mode for light load efficiency
  • 100% duty cycle for lowest dropout
  • Active output discharge
  • Power-good output
  • Thermal shutdown protection
  • Hiccup short-circuit protection
  • A forced-PWM version for CCM operation
  • Create a custom design using the TPS6282x with the WEBENCH Power Designer
  • Available as an integrated-inductor power module: TPSM82821, TPSM82822, and TPSM82823
  • DCS-Control topology
  • 1% feedback or output voltage accuracy (full temperature range)
  • Up to 97% efficiency
  • 26mΩ and 25mΩ internal power MOSFETs
  • 2.4V to 5.5V input voltage range
  • 4µA operating quiescent current
  • 2.2MHz switching frequency
  • 0.6V to 4V adjustable output voltage
  • Power save mode for light load efficiency
  • 100% duty cycle for lowest dropout
  • Active output discharge
  • Power-good output
  • Thermal shutdown protection
  • Hiccup short-circuit protection
  • A forced-PWM version for CCM operation
  • Create a custom design using the TPS6282x with the WEBENCH Power Designer

The TPS6282x is an easy-to-use, synchronous step-down DC/DC converters family with a very low quiescent current of only 4µA. Based on the DCS-Control topology, the device provides a fast transient response. The internal reference allows to regulate the output voltage down to 0.6V with a high feedback voltage accuracy of 1% over the junction temperature range of –40°C to 125°C. The family devices are pin-to-pin and BOM-to-BOM compatible. The entire design requires a small 470nH inductor, a single 4.7µF input capacitor, and two 10µF or single 22µF output capacitor.

The TPS6282x is available in two flavors. The first includes an automatically entered power save mode to maintain high efficiency down to very light loads for extending the system battery run-time. The second runs in forced-PWM maintaining a continuous conduction mode to make sure of the least ripple in the output voltage and a quasi-fixed switching frequency. The device features a Power-Good signal and an internal soft-start circuit. The device is able to operate in 100% mode. For fault protection, the device incorporates a HICCUP short-circuit protection as well as a thermal shutdown. The device is available in a 6-pin 1.5mm × 1.5mm QFN package, offering the highest power density design.

The TPS6282x is an easy-to-use, synchronous step-down DC/DC converters family with a very low quiescent current of only 4µA. Based on the DCS-Control topology, the device provides a fast transient response. The internal reference allows to regulate the output voltage down to 0.6V with a high feedback voltage accuracy of 1% over the junction temperature range of –40°C to 125°C. The family devices are pin-to-pin and BOM-to-BOM compatible. The entire design requires a small 470nH inductor, a single 4.7µF input capacitor, and two 10µF or single 22µF output capacitor.

The TPS6282x is available in two flavors. The first includes an automatically entered power save mode to maintain high efficiency down to very light loads for extending the system battery run-time. The second runs in forced-PWM maintaining a continuous conduction mode to make sure of the least ripple in the output voltage and a quasi-fixed switching frequency. The device features a Power-Good signal and an internal soft-start circuit. The device is able to operate in 100% mode. For fault protection, the device incorporates a HICCUP short-circuit protection as well as a thermal shutdown. The device is available in a 6-pin 1.5mm × 1.5mm QFN package, offering the highest power density design.

다운로드 스크립트와 함께 비디오 보기 동영상

관심 가지실만한 유사 제품

open-in-new 대안 비교
비교 대상 장치와 동일한 기능을 지원하는 핀 대 핀
TLV62595 활성 2.5V~5.5V 입력, 4A 감압 컨버터 - 1% 출력 정확성, 1.5mm × 1.5mm QFN 패키지 Cost-optimized solution (2.4 V to 5.5 VIN)
TPS62827 활성 2.5V~5.5V 입력, 4A 스텝다운 컨버터 - 1% 출력 정확성, 1.5mm × 1.5mm QFN 패키지 Pin-to-pin solution with automatic PWM/PFM mode
다른 핀 출력을 지원하지만 비교 대상 장치와 동일한 기능
TPS62864 활성 1.05mm x 1.78mm WCSP 패키지의 I2C 인터페이스를 지원하는 4A 동기 스텝다운 컨버터 Dynamic voltage scaling (DVS), small solution size
비교 대상 장치와 유사한 기능
TPSM82810 활성 3x4mm μSIP 패키지에서 조정 가능한 주파수 및 추적을 지원하는 2.75V~6V, 4A 스텝다운 모듈 Module with integrated inductor and mode selection pin for PWM/PFM or FPWM.

기술 자료

star =TI에서 선정한 이 제품의 인기 문서
검색된 결과가 없습니다. 검색어를 지우고 다시 시도하십시오.
10개 모두 보기
유형 직함 날짜
* Data sheet TPS6282x 2.4V to 5.5V Input, 1, 2, 3, 4A Step-Down Converter With 1% Output Accuracy datasheet (Rev. I) PDF | HTML 2024/03/11
EVM User's guide TPS6282xAEVM-126 Evaluation Module (Rev. A) PDF | HTML 2021/03/24
White paper Enabling Higher Data Rates for Optical Modules With Small and Efficient Power 2021/03/22
Application brief Powering VCCINT_VCU Rail in Xilinx® Zynq®UltraScale+™ Family of Multiprocessors PDF | HTML 2020/06/08
Analog Design Journal Methods of output-voltage adjustment for DC/DC converters 2019/06/14
Technical article QFN soldering tips and tricks PDF | HTML 2018/11/26
Analog Design Journal Understanding 100% mode in low-power DC/DC converters 2018/06/22
Analog Design Journal Achieving a clean startup by using a DC/DC converter with a precise enable-pin threshold 2017/10/24
Analog Design Journal Testing tips for applying external power to supply outputs without an input voltage 2016/10/24
Analog Design Journal Understanding frequency variation in the DCS-Control(TM) topology 2015/10/30

설계 및 개발

추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.

평가 보드

TPS62827AEVM-126 — TPS62827A 5.5V 입력, 4A 출력 동기 감압 컨버터 1% Vout 정확도 평가 모듈

TPS62827AEVM-126 평가 모듈은 TPS62827A 평가에 사용됩니다. TPS6282xA 장치 제품군은 DCS-Control™ 토폴로지를 기반으로 하는 사용하기 쉬운 동기 강압 DC/DC 컨버터로, 빠른 과도 응답을 제공합니다. 내부 레퍼런스를 통해 -40°C~125°C의 접합부 온도 범위에서 1%의 높은 피드백 전압 정확도로 출력 전압을 최저 0.6V까지 조절할 수 있습니다. 전체 솔루션에는 소형 470nH 인덕터, 단일 4.7μF 입력 커패시터 및 3개의 10μF 출력 커패시터가 필요합니다. 이 장치는 (...)
사용 설명서: PDF | HTML
TI.com에서 구매 불가
시뮬레이션 모델

TPS62827A PSpice Unencrypted Transient Model

SLYM117.ZIP (287 KB) - PSpice Model
패키지 CAD 기호, 풋프린트 및 3D 모델
VSON-HR (DMQ) 6 Ultra Librarian

주문 및 품질

포함된 정보:
  • RoHS
  • REACH
  • 디바이스 마킹
  • 납 마감/볼 재질
  • MSL 등급/피크 리플로우
  • MTBF/FIT 예측
  • 물질 성분
  • 인증 요약
  • 지속적인 신뢰성 모니터링
포함된 정보:
  • 팹 위치
  • 조립 위치

지원 및 교육

TI 엔지니어의 기술 지원을 받을 수 있는 TI E2E™ 포럼

콘텐츠는 TI 및 커뮤니티 기고자에 의해 "있는 그대로" 제공되며 TI의 사양으로 간주되지 않습니다. 사용 약관을 참조하십시오.

품질, 패키징, TI에서 주문하는 데 대한 질문이 있다면 TI 지원을 방문하세요. ​​​​​​​​​​​​​​

동영상