홈 전원 관리 AC/DC 및 DC/DC 컨버터(통합 FET)
홈
전원 관리
AC/DC 및 DC/DC 컨버터(통합 FET)

LM5009

활성

9.5~95V 넓은 입력 전압 범위, 150mA COT(Constant-On-Time) 비동기형 벅 레귤레이터

지금 주문
데이터 시트

이 제품의 최신 버전이 있습니다

open-in-new 대안 비교
다른 핀 출력을 지원하지만 비교 대상 장치와 동일한 기능
LM5163 활성 초저 IQ를 지원하는 100V 입력, 0.5A 동기 벅 DC/DC 컨버터 Synchronous rectification for smaller footprint and high efficiency and low IQ.

LM5009

활성
데이터 시트 지금 주문

제품 상세 정보

Rating Catalog Operating temperature range (°C) -40 to 125 Topology Buck Type Converter Iout (max) (A) 0.15 Vin (min) (V) 9.5 Vin (max) (V) 95 Switching frequency (min) (kHz) 50 Switching frequency (max) (kHz) 600 Features Enable, Over Current Protection Control mode Constant on-time (COT) Vout (min) (V) 2.5 Vout (max) (V) 85 Iq (typ) (µA) 485 Duty cycle (max) (%) 99
Rating Catalog Operating temperature range (°C) -40 to 125 Topology Buck Type Converter Iout (max) (A) 0.15 Vin (min) (V) 9.5 Vin (max) (V) 95 Switching frequency (min) (kHz) 50 Switching frequency (max) (kHz) 600 Features Enable, Over Current Protection Control mode Constant on-time (COT) Vout (min) (V) 2.5 Vout (max) (V) 85 Iq (typ) (µA) 485 Duty cycle (max) (%) 99
VSSOP (DGK) 8 14.7 mm² 3 x 4.9 WSON (NGU) 8 16 mm² 4 x 4
  • Newer product: LM5163 100-V, 0.5-A synchronous buck DC/DC converter
  • Integrated N-channel MOSFET
  • 150-mA output current capability
  • Ultra-fast transient response
  • No loop compensation required
  • VIN feedforward provides constant operating frequency
  • Switching frequency can exceed 600 kHz
  • Highly efficient operation
  • 2% accurate 2.5-V feedback from –40°C to +125°C
  • Internal start-up regulator
  • Intelligent current limit protection
  • External shutdown control
  • Thermal shutdown
  • 8-pin VSSOP and thermally enhanced 8-pin WSON packages
  • Newer product: LM5163 100-V, 0.5-A synchronous buck DC/DC converter
  • Integrated N-channel MOSFET
  • 150-mA output current capability
  • Ultra-fast transient response
  • No loop compensation required
  • VIN feedforward provides constant operating frequency
  • Switching frequency can exceed 600 kHz
  • Highly efficient operation
  • 2% accurate 2.5-V feedback from –40°C to +125°C
  • Internal start-up regulator
  • Intelligent current limit protection
  • External shutdown control
  • Thermal shutdown
  • 8-pin VSSOP and thermally enhanced 8-pin WSON packages

The LM5009 step-down switching regulator features all of the functions needed to implement a low-cost and efficient, buck regulator. This device is capable of driving a 150-mA load current from a 9.5-V to 95-V input source. The switching frequency can exceed 600 kHz, depending on the input and output voltages. The output voltage can be set from 2.5 V to 85 V. This high-voltage regulator contains an N-channel buck switch and an internal startup regulator. The device is easy to implement and is provided in 8-pin VSSOP and thermally-enhanced, 8-pin WSON packages. The regulator operation is based on a control scheme using an on-time inversely proportional to VIN. This feature allows the operating frequency to remain relatively constant over load and input voltage variations. The control scheme requires no loop compensation, resulting in an ultrafast transient response. An intelligent current limit is implemented with forced off-time that is inversely proportional to VOUT. This scheme ensures short-circuit protection and provides minimum foldback. Other features include thermal shutdown, VCC undervoltage lockout, gate drive undervoltage lockout, and maximum duty cycle limiter.

The new product LM5163 offers reduced BOM count, reduced solution size, lower operating quiescent current and many other features. Start WEBENCH design with LM5163.

The LM5009 step-down switching regulator features all of the functions needed to implement a low-cost and efficient, buck regulator. This device is capable of driving a 150-mA load current from a 9.5-V to 95-V input source. The switching frequency can exceed 600 kHz, depending on the input and output voltages. The output voltage can be set from 2.5 V to 85 V. This high-voltage regulator contains an N-channel buck switch and an internal startup regulator. The device is easy to implement and is provided in 8-pin VSSOP and thermally-enhanced, 8-pin WSON packages. The regulator operation is based on a control scheme using an on-time inversely proportional to VIN. This feature allows the operating frequency to remain relatively constant over load and input voltage variations. The control scheme requires no loop compensation, resulting in an ultrafast transient response. An intelligent current limit is implemented with forced off-time that is inversely proportional to VOUT. This scheme ensures short-circuit protection and provides minimum foldback. Other features include thermal shutdown, VCC undervoltage lockout, gate drive undervoltage lockout, and maximum duty cycle limiter.

The new product LM5163 offers reduced BOM count, reduced solution size, lower operating quiescent current and many other features. Start WEBENCH design with LM5163.
filter 기타 AC/DC 및 DC/DC 컨버터(통합 FET) 찾기
다운로드 스크립트와 함께 비디오 보기 동영상

기술 자료

star =TI에서 선정한 이 제품의 인기 문서
검색된 결과가 없습니다. 검색어를 지우고 다시 시도하십시오.
13개 모두 보기
유형 직함 날짜
* Data sheet LM5009 Wide Input, 100-V,150-mA, Step-Down Switching Regulator datasheet (Rev. I) PDF | HTML 2021/05/25
Application note Stability Analysis and Design of COT Type-3 Ripple Circuit 2019/03/20
Selection guide Power Management Guide 2018 (Rev. R) 2018/06/25
Technical article Simplifying 100V wide VIN power conversion PDF | HTML 2016/11/11
Technical article Who tampered with my PLC? Are industrial control systems too flexible? PDF | HTML 2016/08/05
White paper Wide VIN power management ICs simplify white paper (Rev. A) 2013/09/19
Application note AN-1820 LM5032 Interleaved Boost Converter (Rev. A) 2013/05/06
EVM User's guide AN-1962 LM5032 Interleaved Boost Evaluation Board (Rev. A) 2013/05/06
EVM User's guide AN-1445 LM5009 Evaluation Board (Rev. D) 2013/04/30
EVM User's guide AN-1955 LM5009A Evaluation Board (Rev. A) 2013/04/30
Application note Analysis & Design of Hysteretic Constant Freq Buck Regr Using the LM5007 (Rev. B) 2013/04/30
Application note Boot Capacitor Regulation in LM25007 Constant-On-Time (COT) Converter (Rev. A) 2013/04/23
Application note Controlling Output Ripple & Achiev ESR Indep Constant On-Time Reg Designs (Rev. A) 2013/04/23

설계 및 개발

추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.

평가 보드

LM5009EVAL — 150mA, 100V 넓은 Vin 스텝다운 스위칭 레귤레이터 평가 모듈

LM5009 150mA, 100V Step-Down Switching Regulator

사용 설명서: PDF
TI.com에서 구매 불가
시뮬레이션 모델

LM5009 PSpice Transient Model

SNVM417.ZIP (174 KB) - PSpice Model
다운로드
시뮬레이션 모델

LM5009 TINA-TI Transient Reference Design

SNVM035.TSC (141 KB) - TINA-TI Reference Design
다운로드
시뮬레이션 모델

LM5009 TINA-TI Transient Spice Model

SNVM036.ZIP (15 KB) - TINA-TI Spice Model
다운로드
시뮬레이션 모델

LM5009 Unencrypted PSpice Transient Model

SNVM954.ZIP (2 KB) - PSpice Model
다운로드
계산 툴

LM5009QUICK-CALC — LM5009 Quick Start Calculator

지원되는 제품 및 하드웨어

지원되는 제품 및 하드웨어

제품
AC/DC 및 DC/DC 컨버터(통합 FET)
LM5009 — 9.5~95V 넓은 입력 전압 범위, 150mA COT(Constant-On-Time) 비동기형 벅 레귤레이터
다운로드
레퍼런스 디자인

TIDA-01552 — 디지털 출력 모듈을 위한 8채널, 2A 고압측 드라이버 레퍼런스 디자인

This eight-channel, parallel, 2-A, high-side, digital output reference design for factory automation applications like PLCs shows the diagnostic features and the power density of new Texas Instruments high-side driver components (such as TPS27S100). Each output can individually measure the output (...)
Design guide: PDF
회로도: PDF
레퍼런스 디자인

TIDA-00236 — PLC용 저압측 0.5A 8채널 디지털 출력 모듈

Digital Output Modules are a standard component in a PLC/PAC or DCS to control actuators, motors and other resistive, capacitive or inductive loads. Customers will benefit from this integrated protected low side drivers and the low pin count control interface which saves pins and isolation (...)
Design guide: PDF
회로도: PDF
패키지 핀 CAD 기호, 풋프린트 및 3D 모델
VSSOP (DGK) 8 Ultra Librarian
WSON (NGU) 8 Ultra Librarian
TI의 평가 항목에 대한 표준 약관이 적용됩니다.

주문 및 품질

포함된 정보:
  • RoHS
  • REACH
  • 디바이스 마킹
  • 납 마감/볼 재질
  • MSL 등급/피크 리플로우
  • MTBF/FIT 예측
  • 물질 성분
  • 인증 요약
  • 지속적인 신뢰성 모니터링
포함된 정보:
  • 팹 위치
  • 조립 위치

지원 및 교육

TI 엔지니어의 기술 지원을 받을 수 있는 TI E2E™ 포럼

포럼 주제 모두 보기(영문)

콘텐츠는 TI 및 커뮤니티 기고자에 의해 "있는 그대로" 제공되며 TI의 사양으로 간주되지 않습니다. 사용 약관을 참조하십시오.

품질, 패키징, TI에서 주문하는 데 대한 질문이 있다면 TI 지원을 방문하세요. ​​​​​​​​​​​​​​

동영상