전원 관리 AC/DC 및 DC/DC 컨트롤러(외장 FET)

LM51770

활성

78V 넓은 VIN 양방향 4 스위치 벅-부스트 컨트롤러

제품 상세 정보

Vin (min) (V) 2.8 Vin (max) (V) 78 Operating temperature range (°C) -40 to 125 Topology Buck-Boost Rating Catalog Vout (min) (V) 3.3 Vout (max) (V) 60 Features Adjustable UVLO, Adjustable current limit, Dynamic Voltage Scaling, Enable, Frequency synchronization, Light Load Efficiency, Load Disconnect, Power good, Spread Spectrum, Synchronous Rectification, Tracking, UVLO adjustable Iq (typ) (µA) 60 Duty cycle (max) (%) 100
Vin (min) (V) 2.8 Vin (max) (V) 78 Operating temperature range (°C) -40 to 125 Topology Buck-Boost Rating Catalog Vout (min) (V) 3.3 Vout (max) (V) 60 Features Adjustable UVLO, Adjustable current limit, Dynamic Voltage Scaling, Enable, Frequency synchronization, Light Load Efficiency, Load Disconnect, Power good, Spread Spectrum, Synchronous Rectification, Tracking, UVLO adjustable Iq (typ) (µA) 60 Duty cycle (max) (%) 100
HTSSOP (DCP) 38 62.08 mm² 9.7 x 6.4
  • Wide input range from 3.5V to 78V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 1.8MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection
  • Wide input range from 3.5V to 78V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 1.8MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection

The LM51770 is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output currentThe LM51770 runs at a fixed switching frequency, which can be set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor can help monitor and limit input and output current of the LM51770. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).

The LM51770 is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output currentThe LM51770 runs at a fixed switching frequency, which can be set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor can help monitor and limit input and output current of the LM51770. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).

다운로드 스크립트와 함께 비디오 보기 동영상

기술 자료

star =TI에서 선정한 이 제품의 인기 문서
검색된 결과가 없습니다. 검색어를 지우고 다시 시도하십시오.
9개 모두 보기
유형 직함 날짜
* Data sheet LM51770 78-V Wide VIN Bidirectional 4-Switch Buck-Boost Controller datasheet PDF | HTML 2024/12/06
Application brief Current Monitoring with Positive and Negative Currents on LM5177x Devices (Rev. A) PDF | HTML 2024/11/25
Application note Reverse Current Operation of the LM5177 Buck-Boost Converter PDF | HTML 2024/07/16
Application note Parallel Operation of the Buck-Boost Converters Using LM5177 Buck-Boost Controller (Rev. A) PDF | HTML 2024/02/27
Application brief A Simple Constant Voltage Regulation Using the MODE Pin (Rev. A) PDF | HTML 2024/02/15
Application brief LM5177 4-스위치 벅 부스트 컨트롤러로 동적 전류 추적 PDF | HTML 2023/09/19
Application note Layout Optimization of 4-Switch Buck-Boost Converters PDF | HTML 2023/09/05
Application brief Precise Current Limiter Over Wide Operation Voltages in Buck-Boost Converters PDF | HTML 2023/09/05
Application brief Constant Current Operation Using the Internal Current Limiter 2023/01/27

설계 및 개발

추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.

평가 보드

LM5177EVM-HP — 4스위치 벅 부스트 컨트롤러를 포함하는 LM5177 평가 모듈

LM5177EVM-HP는 LM5177 와이드 VIN 벅 부스트 컨트롤러를 사용하여 유연한 고전력 벅 부스트 설계를 시연합니다. 평가 모듈은 4.2V~36V의 입력 전압 범위에서 작동하도록 구성되어 있으며, 최대 9.4A의 부하 전류로 조정된 16V 출력을 제공합니다.
사용 설명서: PDF | HTML
TI.com에서 구매 불가
계산 툴

LM51770-QUICKSTART-CALC LM51770 BuckBoost Quickstart Calculator Tool

LM51770 BuckBoost Quickstart Calculator Tool. This standalone tool facilitates and assists the power supply engineer with the design of a DC/DC buck-boost converter based on the LM51770.
지원되는 제품 및 하드웨어

지원되는 제품 및 하드웨어

제품
AC/DC 및 DC/DC 컨트롤러(외장 FET)
LM51770 78V 넓은 VIN 양방향 4 스위치 벅-부스트 컨트롤러
패키지 CAD 기호, 풋프린트 및 3D 모델
HTSSOP (DCP) 38 Ultra Librarian

주문 및 품질

포함된 정보:
  • RoHS
  • REACH
  • 디바이스 마킹
  • 납 마감/볼 재질
  • MSL 등급/피크 리플로우
  • MTBF/FIT 예측
  • 물질 성분
  • 인증 요약
  • 지속적인 신뢰성 모니터링
포함된 정보:
  • 팹 위치
  • 조립 위치

지원 및 교육

TI 엔지니어의 기술 지원을 받을 수 있는 TI E2E™ 포럼

콘텐츠는 TI 및 커뮤니티 기고자에 의해 "있는 그대로" 제공되며 TI의 사양으로 간주되지 않습니다. 사용 약관을 참조하십시오.

품질, 패키징, TI에서 주문하는 데 대한 질문이 있다면 TI 지원을 방문하세요. ​​​​​​​​​​​​​​

동영상